609100
9
Zoom out
Zoom in
Previous page
1/11
Next page
34
INCORPORATED SAFETY DEVICES
35
CLEANING/MAINTENANCE
After a steam outflow, always drain the
machine, otherwise the coffee
brewing program automatically stops, due to
excessive temperature.
If the machine is on the steam mode,
the automatic coffee brewing is pre-
vented.
Press the steam selection button
and wait
until the green temperature warning light
turns on.
Direct the steam/hot water dispenser (5) over
the cup holder grill (3) and slightly open knob
(6), turning it counterclockwise.
Wait until the remaining water has flown out of
the spout.
Then move the spout outwards and immerse it
into the fluid to heat.
32 Slowly open the steam/hot water knob and
heat the fluid, using a circular movement from
bottom to top.
When the fluid has reached the desired tempera-
ture, close the knob and immediately clean the
spout with a damp cloth.
Warning: the spout is hot, it may cause burns!
As soon as the steam/hot water dispensing is
finished, position the steam/hot water dispensing
tube over the cup holder grill and disactivate the
steam function by pressing the steam selection
button.
Then open the steam/hot water knob again and
drain the machine (the pump automatically starts)
until the water flows regularly from the dispensing
tube (see the chapter relevant to Drainage, page.
30) and the temperature warning light stops
blinking.
Close the steam/hot water knob.
The machine is ready to brew coffee again.
Cappuccino froth
Fill a cup 1/3 with cold fresh milk, then immerse
the steam/hot water dispensing tube (5) just
below the milk surface.
Move the cup with a circular movement to form a
thick froth. Then immerse the dispensing tube deep
into the milk to heat it.
Incorporated safety devices
Automatic off
Should the service door be open, the machine
automatically switches off and its operation is thus
prevented.
If the central unit is not mounted, only water and
steam can be dispensed.
Electronic grinding time control
As soon as the coffee bean container is empty, the
machine automatically stops after approx. 20
seconds.
Fill the container with coffee bean. The coffee
brewing cycle can be restarted.
Electronic pump control
The machine switches off automatically as soon as
the water tank is empty.
Automatic temperature adjustment
This adjustment controls the correct temperature
to brew coffee and to dispense hot water and
steam.
Coffee brewing is automatically interrupted should
the water temperature be too low or too high
(safety thermostat and overheating safety device
activated).
Antigravel device
Even selected coffees may contain some impuri-
ties.
The coffee grinder is fitted with an antigravel
device to avoid any damage.
Should gravel end up into the coffee grinder, you
will hear a strong and characteristic noise. Stop
the machine immediately, otherwise the protec-
tion system will stop the coffee grinder after
approx. 20 seconds.
Important: Do not start the machine until the matter
has been removed, otherwise the motor may be
damaged.
Procedures: see page 36, points 38-42.
Cleaning/Maintenance
Cleaning
To ensure high coffee quality and a longer
working life of the machine, always keep the
machine clean.
Before cleaning the machine, turn off
the main switch and unplug the ma-
chine.
Before cleaning the machine, wait
until it cools down.
Do not immerse the machine into water
or other fluids (it may be dam-
aged).
Do not wash parts of the machine in the
dishwasher.
Always handdry all parts of the ma-
chine; do not dry them in the oven or
microwave oven!
Water tank/ Drip tray/Coffee grounds con-
tainer/Coffee dispensing unit/Coffee ma-
chine
33 In order to keep the dispensing area and the
central unit (16) clean, it is recommended to
empty the coffee grounds container (1) every
day.
The water tank (8), drip tray (2), cup holder grill
(3) and coffee grounds container should be
washed periodically, using a non-abrasive sol-
vent and drying them carefully.
34 The coffee dispenser (4) may be removed for
cleaning operations.
Unloose the the screws and rinse the dispensing
tubes thoroughly with hot water.
From time to time, clean the machine casing with
a damp cloth and dry it.
Clean the pre-ground coffee container (14) with
the aid of the brush supplied, whenever neces-
sary.
Central unit
Clean the central unit (16) whenever the coffee
bean container has been re-filled, or at least once
or twice a week.
Switch off the machine by pressing the main
switch and open the service door (15).
Remove the coffee grounds container (1).
35 Remove the central unit (16) by holding it by
the handle and pressing the "PRESS" key.
Wash the central unit with hot water.
Make sure there are no coffee residues on the two
chrome-steel filters.
Dry it thoroughly.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips-Saeco SUP 012 Magic de Luxe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips-Saeco SUP 012 Magic de Luxe in the language / languages: English as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info