507553
20
Zoom out
Zoom in
Previous page
1/120
Next page
• 20 •
4 INSTALLATION
For your own and other people safety, carefully follow
the "Safety Regulations" indicated in chapter 3.
4.1 Packaging
The original packaging has been designed and manufactured
to protect the machine during transport. We recommend
keeping the packaging material for possible future transport.
4.2 Installation Precautions
Before installing the machine, read the following safety pre-
cautions carefully:
Place the machine in a safe place.
Make sure children cannot play with the machine.
Do not place the machine on hot surfaces or near open
 a m e s .
The co ee machine is now ready to be connected to the electric
network.
Note: we recommend washing the components
before using them for the  rst time and/or af-
ter they have not been used for a certain period of time.
4.3 Machine Connection
Electric power may be very dangerous! It is
therefore necessary to strictly follow the safety
regulations. Do not use faulty power cords. Faulty cords
and plugs must be replaced immediately by Authorised
Service Centres.
The voltage of the appliance has been pre-set by the manu-
facturer. Check that the voltage matches the indication on the
data plate at the bottom of the appliance.
Insert the plug into a wall socket with suitable power volt-
age.
4.4 Water tank
(Fig.1A) - Remove the lid from the water tank (2) by lifting
it.
(Fig.1B) - Remove the water tank (5).
(Fig.2) - Rinse it and  ll it with fresh drinking water: do
not exceed the (MAX) level indicated in the water tank.
Fill the tank only with fresh, non-sparkling,
drinking water. Hot water or any other liquid
may damage the tank. Do not operate the machine
without water: make sure that there is enough water
in the tank.
(Fig.3A) - Insert the water tank making sure that it has
been properly repositioned in its former seat and then
reposition the lid (2).
Make sure that the tank is fully inserted in the
machine by pressing it gently up to its limit stop
(THE REFERENCE MARK SHOWN IN FIG.3B SHOULD BE
COMPLETELY VISIBLE). This is to avoid water leaks from
its bottom.
4.5 Circuit Priming
At the beginning, after dispensing steam or when the water
tank is empty, the machine’s water circuit must be primed.
Press the ON/OFF button (11); the light (18) will turn on to
indicate that the machine is on.
(Fig.4) - Place a container under the steam wand (Pan-
narello).
Open the “hot water/steam” knob (3) by turning it coun-
ter-clockwise.
(Fig.5) - Set the selection knob (17) to the "
" position.
Wait until a steady jet of water  ows out of the steam
wand (Pannarello).
(Fig.5) - Set the selection knob (17) to the "
" position.
Close the "hot water/steam" knob (3) by turning it clock-
wise. Remove the container.
4.6 Using the Machine for the First Time
or After a Period of Inactivity
This simple operation ensures an optimum brewing and must
be performed:
- at  rst start-up;
- when the machine remains inactive for a long time (more
than 2 weeks).
Dispensed water must be emptied into an ad-
equate drain. It is not suitable for food use. If
the container  lls up during the cycle, stop dispensing
water and empty the container before resuming the
operation.
(Fig.2) - Rinse the tank and  ll it again with fresh drinking
water.
(Fig.4) - Place a container under the steam wand (Pan-
narello). Open the knob (3) by turning it counter-clockwise.
(Fig.5) - Set the selection knob (17) to the "
" position.
Dispense the whole water tank content from the steam/
hot water wand (Pannarello). To end the operation, set the
selection knob (17) to the "
" position and close the knob
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips-Saeco HD 8423 Poemia at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips-Saeco HD 8423 Poemia in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info