692448
10
Zoom out
Zoom in
Previous page
1/21
Next page
Initial operation 9
Battery power operation
The projector can be also operated on built-in
battery for portability.
Charging projector
Before first use, charge the projector for
2 hours. Two options are available to charge the
projector.
Option 1:
Adjust the switch to the
position.
Using the included power adapter, connect
the DC jack on the projector to the wall
outlet.
Option 2:
To charge the projector through USB, turn
off the projector by adjusting the
switch.
Using a USB cable (not included), connect
the Micro USB port (DC 5V) on the back
of the projector to a power bank or other
mains charger (DC 5V).
Notice
The projector cannot be turned on using
USB power (DC 5V).
Switch on/off battery power
To switch on or off the battery power
supply, adjust the switch on the
projector. When the battery power supply is
switched on, the LED on the projector turns
red.
USBHDMIOFF/ON
OFF/ON
For normal use, the fully charged
projector can be operated for 60
minutes.
Notice
The capacity of the built-in battery
diminishes with time. If the projector
functions only with AC power supply, the
built-in battery is defective. Contact an
authorised service centre to replace the
built-in battery.
DANGER!
Risk of explosion with incorrect type
of batteries!
There is a risk of explosion if the
incorrect battery type is used.
Do not try to replace the built-in
battery yourself.
Preparing the remote
control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
When using the remote control, point
the remote control at the rear side of the
projector where the IR sensor is located,
and make sure there is no obstacle
between the remote control and the rear
side of the projector.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips NeoPix Start Plus NPX245 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips NeoPix Start Plus NPX245 in the language / languages: English as an attachment in your email.

The manual is 4,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips NeoPix Start Plus NPX245

Philips NeoPix Start Plus NPX245 User Manual - German - 22 pages

Philips NeoPix Start Plus NPX245 User Manual - Dutch - 21 pages

Philips NeoPix Start Plus NPX245 User Manual - French - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info