664862
39
Zoom out
Zoom in
Previous page
1/42
Next page
37EN
I cannot change the settings of my
voice mail, what do I do?
The voice mail service is managed by
your service provider but not the phone
itself. Contact your service provider to
change the settings.
The handset on the charger does not
charge or the battery discharges too
fast.
Make sure the batteries are inserted
correctly.
Make sure the handset is placed
properly on the charger. If the
docking tone is turned on, you can
hear the docking tone when you
place the handset on the charging
cradle.
The charging contacts are dirty.
Disconnect the power supply rst
and clean the contacts with a damp
cloth.
The battery is not fully recharged.
Leave the handset on the charging
cradle for at least 8 hours or until
the battery icon on the handset
stops scrolling and indicates full bar.
The batteries are old or defective.
Purchase and replace with new
rechargeable batteries with the
same specications. To remove the
battery door, refer to the instruction
in the following picture.
No display.
Make sure the batteries are
charged.
Make sure there is power and the
phone is connected.
Bad audio (crackles, echo, etc.).
The handset is nearly out of range.
Move it closer to the base station.
The phone receives interference
from the nearby electrical
appliances. Move the base station
away from them.
The phone is at a location with thick
walls. Move the base away from
them.
The phone receives interference
from the DSL (digital subscriber
line) connection. Install a DSL lter
to prevent the noise. Contact your
service provider for the DSL lter.
The handset does not ring.
Make sure the handset ringtone is
turned on.
Make sure the handset is registered
to the base station.
The caller ID does not display.
The service is not activated. Check
with your service provider.
The caller's information is withheld
or unavailable.
The handset cannot display characters
* and #.
Characters * and # respectively appear
as small ‘n’ and small ‘o’ in the LCD
display. This is normal behavior because
of the 7-segment in the 2nd row of the
display (you can nd the characters on
these 4 buttons: and ).
Note
If the above solutions do not help, disconnect
the power supply from both the handset and
base station. Try again after 1 minute.
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips Mira M5602 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips Mira M5602 in the language / languages: English as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips Mira M5602

Philips Mira M5602 Quick start guide - English - 10 pages

Philips Mira M5602 Quick start guide - Dutch - 10 pages

Philips Mira M5602 User Manual - Dutch - 48 pages

Philips Mira M5602 Quick start guide - French - 10 pages

Philips Mira M5602 User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info