381060

Philips hr2850 Manual

3
Zoom out
Zoom in
Previous page
1/9
Next page
Ingredients chopper Quantities
presoaked seeds and
grains, e.g. lotus seed, paste,
rice etc.
20-50g
chili paste (chillies, shallot,
garlic, etc.)
50g
garlic 20-100g
onions 20-100g
meat 30g
2 Make sure the sealing ring is placed properly
onto the chopper blade unit.
3 Place the blade unit on the chopper beaker
(1). Turn the blade unit clockwise to x it
(2) (Fig. 10).
4 Turn the assembled chopper upside down
and place it on the motor unit (1). Turn
the chopper clockwise to fasten it (2)
(‘click’) (Fig. 11).
5 Put the plug in the wall socket and press the
pulse button (Fig. 12).
Hold the motor unit rmly with both hands
when the appliance operates.
Do not operate the chopper for more than 30
seconds at a time.
Tips
If ingredients stick to the blade unit or the
beaker wall or if the appliance shakes because
the food is not evenly distributed, switch off the
appliance. Remove the chopper beaker from
the motor unit. Shake the chopper beaker until
the ingredients come loose or are properly
distributed.
Filter
You can use the lter to obtain delicious fresh fruit
juices, cocktails or soy milk (see section ‘Recipes’ in
this chapter). All pips and skins remain in the lter.
1 Put the lter in the blender beaker (Fig. 13).
Make sure the lter ts properly on the bottom of
the beaker.
2 Put the ingredients in the lter (Fig. 14).
Never ll the lter beyond the MAX indication.
Do not use the lter to process hot ingredients.
3 Pour water or another liquid (milk, juice, etc.)
into the blender beaker.
4 Put the lid on the blender beaker to x the
lter. Make sure that the sieve on the lid is
located in front of the spout of the blender
beaker (Fig. 15).
5 Press the pulse button (Fig. 16)
6 When you have nished processing, release
the pulse button.
Leave the lid on the blender beaker and leave
the lter in the beaker.
7 Remove the blender beaker from the motor
unit. Pour out the drink through the spout of
the blender beaker (Fig. 17).
8 For optimal results, put the beaker with the
remaining ingredients (and some extra liquid,
if necessary) back onto the appliance and let
it run for a few more seconds.
9 Pour out the rest of the drink.
Tips
When you process a large quantity, we advise
you not to put all the ingredients in the lter at
the same time. Start to process a small quantity
and let the appliance run for a few seconds.
-
-
Then release the pulse button and add another
small quantity. Repeat this procedure until you
have processed all the ingredients. Always keep
the lid on the blender beaker during processing.
To get the best result when you make fruit
juices and cocktails, add approx. 150ml water
to 100g fruit. You can also use other liquids, e.g.
to make cocktails.
Soak hard ingredients, e.g. soy beans, before
you process them.
Recipes
Soy milk
This recipe can only be prepared with the lter.
Note: After you have processed one batch, always let
the appliance cool down before you process the next
batch.
Ingredients:
50g dried soy beans
400ml water
1 Soak the soy beans for 4 hours before you
process them. Set them aside to drain.
2 Put the soaked soy beans in the lter. Pour
400ml of water into the blender beaker and
blend for 30 seconds.
3 Bring the soy milk to the boil in a pan, then
add sugar to taste and leave to simmer until
all the sugar has melted.
4 Serve hot or cold.
Carrot juice
Ingredients:
240g carrots
360ml water
1 Cut the carrots into small pieces.
2 Put the water and the pieces of carrot in the
blender beaker.
3 Blend for 1 minute.
Cleaning
Cleaning the appliance is easiest immediately after
use.
Do not touch the cutting edges of the blade units
when you handle or clean them. They are very
sharp and you can easily cut your ngers on them.
Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as petrol or acetone to
clean the appliance.
Note: Parts of the appliance may become discoloured
when the appliance is used to process ingredients
that contain a lot of pigment such as carrots and
tomato paste. This is normal.
1 Unplug the appliance.
2 Remove the blender or chopper from the
motor unit.
3 Clean the motor unit with a moist cloth.
Never immerse the motor unit in water nor rinse
it under the tap.
4 Clean the detachable parts in warm water
with some washing-up liquid and rinse them
under the tap.
If necessary, remove the rubber sealing rings from
the chopper and blender blade units and rinse
them with water.
Do not touch the cutting edges of the blade units
when you handle or clean them. They are very
sharp and you can easily cut your ngers on them.
5 Wind excess mains cord round the base of
the appliance for easy storage (Fig. 18).
-
-
-
-
-
-
Environment
Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an ofcial collection point for
recycling. By doing this, you help to preserve
the environment (Fig. 19).
Guarantee and service
If you need service or information or if you have a
problem, please visit the Philips website at www.
philips.com or contact the Philips Consumer Care
Centre in your country (you nd its phone number
in the worldwide guarantee leaet). If there is no
Consumer Care Centre in your country, go to your
local Philips dealer.
-
4222.002.7032.3
3/9
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips hr2850 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips hr2850 in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info