60757
17
Zoom out
Zoom in
Previous page
1/204
Next page
Problem Solution
There may be a power failure. Test if the power supply works by
connecting another appliance.
The tanning lamps may still be too hot to go on. Let them cool down
for 3 minutes rst.
The overheat protection may have switched off the appliance
automatically because it overheated. Remove the cause of overheating
(e.g. a towel that blocks one or more vents). Let the appliance cool
down for a while and then switch the appliance back on.
Make sure the lamp unit is in the right position. See chapter ‘Preparing
for use’.
The top of the control
panel becomes hot
during use.
The lamps heat up the top of the control panel. This is normal.
The fuse of the circuit to
which the appliance is
connected cuts off the
power when I switch on
or use the appliance.
The fuse of the circuit to which the tanning appliance is connected
must be a 16A standard fuse or a slow-blow automatic fuse. You may
also have connected too many appliances to the same circuit.
The tanning results not
as good as I expected.
Perhaps you use an extension cord that is too long and/or does not
have the correct current rating. Consult your dealer. Our general
advice is not to use an extension cord.
You may have followed a tanning course that is not appropriate
for your skin type. Check the table in chapter ‘Tanning and your health’,
section ‘Tanning sessions: how often and how long?’.
The distance between the lamps and the surface you lie on may be
larger than prescribed. See chapter ‘Preparing for use’.
When the lamps have been used for a long time, the tanning
capacity decreases. This effect only becomes noticeable after several
years. To solve this problem, select a slightly longer tanning time
or have the lamps replaced. HP8565/HP8560 only: after 750 operating
hours, an L appears on the display which tells you that it is advisable to
have the lamps replaced.
The tanning result depends on your skin type and the tanning course
you are taking. The rst effect only becomes visible after a few
sessions.
The appliance does not
produce enough
fragrance.
Read the last part of section ‘Natural fragrances’ in chapter ‘Using the
appliance’.
The display shows ‘Err’
(HP8565/HP8560 only)
and/or the appliance
beeps.
Stop using the appliance and unplug it. Wait two seconds and put the
plug back into the wall socket. Contact your dealer or a Philips service
centre if the problem reoccurs.
ENGLISH 17
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips HP8550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips HP8550 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info