670749
12
Zoom out
Zoom in
Previous page
1/108
Next page
Problem Solution
The lamp does not go
on right away when I
switch it on.
It takes approx. 1 second for the lamp to go on. This is normal, the lamp
needs to heat up.
I do not hear the alarm
sound when the alarm
goes off.
Perhaps you set the sound level too low. See section ‘Radio/volume’ to
set a higher sound level.
Perhaps you switched off the alarm function by setting the control lever
to the top position.
If you selected the radio as the alarm sound, the radio may be
defective. Switch on the radio button after you switch off the alarm to
check if the radio works. If it does not work, contact the Philips
Consumer Care Centre in your country.
The radio does not
work.
The radio may be defective. Contact the Philips Consumer Care
Centre in your country.
The radio produces a
crackling sound.
Perhaps the broadcast signal is weak. Turn the middle selection wheel
(SET) to adjust the frequency and/or change the position of the
antenna.
The alarm went off
yesterday, but it did not
go off today.
Perhaps you switched off the alarm function by setting the control
lever to the top position.
Perhaps you set a too low sound level and/or light intensity level. Set a
higher sound and/or light intensity level.
Perhaps there was a power failure that lasted more than 15 minutes. In
this case the appliance is reset to the factory default settings. Check the
alarm settings (see chapter ‘Using the appliance’).
The light wakes me too
early/too late.
Perhaps the light intensity level you have set is not appropriate for you.
Try a lower light intensity level if you wake up too early or a higher
light intensity level if you wake up too late. If light intensity level 20 is
not high enough, move the appliance closer to the bed.
Perhaps you woke up too late because the appliance is positioned at a
lower level than your head. Make sure the appliance is located at a
height at which the light is not blocked by your bed, duvet or pillow.
Also make sure the appliance is not placed too far away.
The lamp ashes. Perhaps there has been a power failure. It is normal for the lamp to
ash after a power failure.
Perhaps the appliance is not suitable for the voltage to which it is
connected. Make sure that the voltage indicated on the appliance
corresponds to the local mains voltage.
ENGLISH12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips HF3475 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips HF3475 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Portuguese, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info