35638
104
Zoom out
Zoom in
Previous page
1/115
Next page
101
PROBLEM/HINTS SOLUTION
The wrong TV channel
was decoded
(recorded) after you
programmed a
recording using
ShowView System.
bThe programme number of the TV channel is not available in the GUIDE Plus+
®
system or allocation is
wrong.
To change or check the channel data, proceed as follows:
1 Press GUIDE/TV J .
2 Press A I .
3 Select 'Editor' with C M .
4 Select the TV channel using B O or A I .
5 Press C M to go to the right tile.
In case you can receive the selected channel only via an external receiver, press the red
button to select the corresponding source.
6 Press the green button.
7 Enter the programme number of the TV channel using the number buttons.
If the source you have selected is an external receiver, enter the programme number that you
would also enter at the external receiver for this TV channel.
8 Confirm with OK L .
bIf no GUIDE Plus+
®
data is available, enter the right programme number after you have confirmed the
ShowView programme number using OK
L .
TV channels will be
deactivated in the
GUIDE Plus+
®
System
after 24 hours
bThis happens occasionally. To switch on the channels proceed as follows:
1 Press GUIDE/TV J .
2 Press A I .
3 Select 'Editor' using C M .
4 Select the TV channel using B O or A I .
5 Press D K to select the left row.
6 Switch on the TV channel using the red function button D .
7 End with GUIDE/TV J .
No 'VPS/PDC time' in
the GUIDE Plus+
®
System
bThe GUIDE Plus+
®
System just shows the start time. The 'VPS/PDC' time will be taken into account.
There is no channel
overview in the GUIDE
Plus+
®
system
bDVD recorder is switched on: Switch off the DVD recorder to allow data transfer
bThe TV channel that transmits the GUIDE Plus+
®
data is not set properly.
bExternal receiver (satellite receiver, set-top box, cable TV box, ...) (if available) is switched off: switch on the
external receiver
bG-LINK cable is not connected: Connect the G-LINK cable and make the necessary settings to control the
external receiver (see chapter 'The GUIDE Plus+
®
System', section 'Installation of the 'External receiver
1').
bCheck that your external receiver (if available) sends out teletext data through the scartcable.
Connect therefore the scartcable from the external receiver directly to the TV set and call up the teletext
function on the TV set from a TV channel that transmits teletext data. If no teletext appears, your external
receiver can not be used for the GUIDE Plus+
®
system.
Missing or wrong TV
channel in the 'Grid'
screen
bWrong local post code/country was entered
bPlease check your correct channel line up in the 'Grid' screen.
Read therefore the section 'The 'Editor' screen.
When you press
GUIDE/TV
J the
GUIDE Plus+
®
setup
screen will appear
bThe GUIDE Plus+
®
system was not completely installed or local post code was not entered.
1 Check the settings
2 Select the corresponding line using B O or A I and confirm with OK L .
3 For more information on the individual functions, see chapter 'The GUIDE Plus+
®
system',
section 'Setting up the GUIDE Plus+
®
System'.
Before you call an engineer
104


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips HDRW720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips HDRW720 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips HDRW720

Philips HDRW720 User Manual - German - 113 pages

Philips HDRW720 User Manual - Dutch - 114 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info