35638
27
Zoom out
Zoom in
Previous page
1/115
Next page
24
A Switch the receiver on and select programme number 02 on the
receiver or using its remote control.
a My external receiver does not display the programme
number
During installation, the external receiver will be switched to a
different programme number.
- Please check the TV show in the 'Video window' in the left top corner
of the screen.
- Check whether the picture changes during the next step
( OK
L button).
B Read the information on the screen carefully.
Confirm with OK
L .
P The DVD recorder will now attempt to use the G-Link
connection on the external receiver to select a different
programme number (e.g.12). This programme number
depends on your external receiver.
C Has the external receiver been switched to the programme
number displayed on the screen?
If this is the case, select 'YES'.
If no switching has taken place, select 'NO'.
a My external receiver has not switched to the other
programme number.
- Check that the external receiver is connected and switched on.
- Check the connection and position of the G-LINK transmitter.
- For another attempt with a new code of the chosen brand, select 'NO'.
- Confirm with OK
L on the remote control.
- If the receiver has not switched yet, select 'NO' again and confirm with
OK
L . It may take several attempts for a receiver brand.
If you return to the setup screen after confirming 'NO', your receiver
may not have been installed.
- In this case, tune your external receiver to the TV channel which
transmits the GUIDE Plus+
®
information (see table in the section
'General information'). If this TV channel is available at the internal
tuner of the DVD-recorder, select this channel.
- Wait till the GUIDE Plus+
®
information is loaded (24 hours) and try
the switch again.
The control data of external receivers are automatically updated
(completed) via the GUIDE Plus+
®
system. This is done through the
aerial, the cable, or the external receiver. You do not need to bring the
device to a service centre.
- If your receiver still does not switch, note the type and manufacturer of
your external receiver and call the customer support service in your
country. You will find the telephone number on the back of this
instruction manual.
À Your external receiver has now been installed.
Á Press OK
L to return to the setup overview. Check the settings
shown on the screen.
O If the settings are not correct, choose the line in which you
want to change the settings and confirm with OK
L .
 Press the green function button
E to leave the screen.
O If you want to view a demonstration of the GUIDE Plus+
®
system select 'View Demo' with B O and confirm with
OK
L .
If you start the demo, programmed recordings may be deleted.
O If you do not want to see the demonstration of the GUIDE
Plus+
®
system, end using GUIDE/TV J .
The setup process for the GUIDE Plus+
®
system is complete.
Continue with 'Finalise set up of the external receiver'.
a I want to install additional external receivers
When installing additional external receivers, please observe the following:
The external receiver which is controlled by the G-LINK transmitter must
be below the other additional receivers. The IR(infrared) remote control
signal is reflected diagonally upwards and can therefore be used to control
additional external receivers which are above it.
ENGLISH
Initial Installation of the GUIDE Plus+ system
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips HDRW720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips HDRW720 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips HDRW720

Philips HDRW720 User Manual - German - 113 pages

Philips HDRW720 User Manual - Dutch - 114 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info