368463
6
Zoom out
Zoom in
Previous page
1/72
Next page
6
Relaxation and your health (HB977 only)
Warmth has a relaxing effect.Think of what a hot bath or lazing in the sunshine does to you.You can enjoy the same relaxing effect by switching
on the infrared lamps.
Bear in mind the following when you have a relax session:
- Avoid getting too hot. Increase the distance between yourself and the lamps, if necessary.
- If your head gets too hot, cover it or move your body so that less heat is emitted towards your head.
- Close your eyes during a relax session.
- Do not let the relax session last too long (see section 'Relax sessions: how often and how long?').
Relax sessions: how often and how long?
Type HB977 only
If you do not want to get up right away after the tanning session, you can switch on the infrared lamps for a relax session, during which
the infrared lamps keep you warm.
You can also take a relax session without a tanning session.You can do this several times a day (e.g. 30 minutes in the morning and in the
evening).
Preparing for use
The appliance can be easily moved and stored in transport position (fig. 2).
If you want to give your face an extra tan or if you only want to tan a part of your body (i.e. just the legs or the upper half of your
body), make sure you place the appliance at the correct side of the bed (fig. 3).
1 To open the appliance, move the lock slides in the direction of the arrow (fig. 4).
The upper part of the appliance is now unlocked.
2 The upper part comes slightly up (by itself or with a little help) (fig. 5).
3 Grab the handle with both hands and put one foot against the appliance to prevent it from sliding away.Tilt the upper part by pulling the
handle and tracing an arc with it (fig. 6).
Do not tilt the upper part too far.
4 Pull the upper part up and towards you at the same time (fig. 7).
This requires some effort.
5 Move both lamp units sideways as far as possible, until they are in line with each other (fig. 8).
6 The distance between the UV filters and your body must be 65 cm.The distance between the UV filters and the surface on which you
are lying down (e.g. a bed) must be 85 cm (fig. 9).
7 Support the upper part of the stand when you set or adjust the height of the appliance (fig. 10).
Loosen the height adjustment knob (A) by turning it anticlockwise (two or three turns).
8 Put your hand under the horizontal part of the stand and extend the stand to the required height (fig. 11).
9 Firmly fasten the height adjustment knob (A) by turning it clockwise and release the stand (fig. 12).
You can determine whether the appliance has been set to the required height by pulling out the measuring tape (fig. 13).
The measuring tape will automatically rewind if you move the red tab sideways (fig. 14).
10 Turn the centre lamp unit 90c until you hear a click (fig. 15).
Note: the centre lamp unit can only be turned in the direction of the arrow!
The appliance can only be switched on if both the side lamp units and the centre lamp unit have been fully extended and have been put in
the right position.This applies to tanning sessions as well as to relax sessions.
Right position (fig. 16).
The appliance is now ready for use.
Using the appliance
1 Fully unwind the mains cord.
2 Put the plug in the wall socket.
The remote control will show all the functions that need to be adjusted by the user.The tanning or relax session time is shown as 00
(fig. 17).
B
Only HB977 shows symbol l (relax session).
Adjusting functions:
1 Use the ¡™buttons to switch from function to function (fig. 18).
The underlined symbol shows the function you are programming.
2 Selecting tanning, extra tanning or relaxing
Choose symbol if you want to tan your whole body.
Choose symbol and ª if you want to tan your whole body and give your face an extra tan.
Choose º if you want to tan just a part of your body (HB971 only).
Choose symbols ª and º if you want to tan just a part of your body and give your face an extra tan (HB971 only).
Choose if you prefer a relax session (warmth) for the whole body (HB977 only).
Note: In these directions for use, functions are used in the pictures as examples of what may be shown on the display.
ENGLISH
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips hb 977 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips hb 977 in the language / languages: Dutch as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info