578448
24
Zoom out
Zoom in
Previous page
1/156
Next page
Problem Cause Solution
E3 is on the
display.
The bumper is stuck. Press the on/off button to stop the robot. Lift the
robot so that its bumper comes free.
E4 is on the
display.
The robot was lifted while it
was cleaning.
Press the on/off button to stop the robot.
Then press the on/off button again to make the
robot resume cleaning normally.
E5 is on the
display.
The robot is cleaning a dark
or black surface, which triggers
the drop-off sensors. This
causes the robot to move in
an unusual pattern.
Press the on/off button and then move the robot
to a lighter coloured piece of the oor. If the
problem continues to occur on lighter coloured
oors, go to www.philips.com/support or contact
the Consumer Care Centre in your country.
The robot is cleaning a oor
that reects sunlight quite
strongly. This triggers the drop-
off sensors and causes the
robot to move in an unusual
pattern.
Close the curtains to block sunlight from entering
the room.
E6 is on the
display.
The rechargeable battery has
not been inserted correctly.
See chapter ‘Before rst use’ for instructions on
how to insert the rechargeable battery.
The power switch is set to
‘off while the robot is on the
docking station.
Set the power switch to ‘on’.
The robot does
not clean properly.
The bristles of one or both
side brushes are crooked or
bent.
Soak the brush or brushes in warm water for a
while. If this does not restore the bristles to their
proper shape, replace the side brushes.
See chapter ‘Replacement’ for instructions on how
to replace the side brushes.
The lter in the dust container
is dirty.
Clean the lter in the dust container with a cloth
or a toothbrush with soft bristles.
If brushing does not help to clean the lter,
replace the lter with a new one
(see chapter Replacement’).
The suction opening in the
bottom of the dust container
is clogged.
Clean the suction opening
(see chapter ‘Cleaning and maintenance’).
The front wheel is jammed
with hair or other dirt.
Clean the front wheel
(see chapter ‘Cleaning and maintenance’).
The battery can
no longer be
charged or runs
empty very fast.
The rechargeable battery has
reached the end of its life.
Replace the rechargeable battery
(see chapter ‘Replacement’).
The battery of the
remote control
runs empty too
fast.
Perhaps you did not insert the
correct type of battery.
For the remote control, you need a CR2025
coin-shaped battery. If the problem persists,
go to www.philips.com/support or contact the
Consumer Care Centre in your country.
ENGLISH24
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips FC8820 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips FC8820 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 15,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info