Manual Philips FC8772 Robot - SmartPro Compact (page 13 of 130) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

673188

Zoom out

Zoom in

1/130

Replacing the battery of the remote control

The remote control works on a CR2025 coin-shaped battery. Replace the battery when the robot no

longer responds when you press the buttons on the remote control.

1 Hold the remote control upside down. Push the release button on the battery holder and at the

same time slide the battery holder out of the remote control (Fig. 47).

2 Remove the empty battery from the battery holder and place a new battery in the battery holder.

Then slide the battery holder back into the remote control (Fig. 48).

Storage

When you are not going to use the robot for more than one month, press the start/stop button on the

robot for 3 seconds to make the robot enter deep sleep mode to protect its rechargeable battery.

Unplug the docking station to save energy.

Removing the rechargeable battery

Warning: Only remove the rechargeable battery when you discard the appliance. Make

sure the battery is completely empty when you remove it.

To remove the rechargeable battery, follow the instructions below. You can also take the robot to a

Philips service center to have the rechargeable battery removed. Contact the Philips Consumer Care

Center in your country for the address of a service center near you.

1 Start the robot from a place somewhere in the room and not from the docking station.

2 Let the robot run until the rechargeable battery is empty to make sure that the rechargeable

battery is completely discharged before you remove it and dispose of it.

3 Undo the screws of the battery compartment lid and remove the lid (Fig. 49).

4 Lift out the rechargeable battery and disconnect it (Fig. 50).

5 Take the robot and the rechargeable battery to a collection point for electrical and electronic

waste.

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you

are unable to solve the problem with the information below, visit www.philips.com/support for a list

of frequently asked questions or contact the Consumer Care Center in your country.

Problem

Possible cause Solution

The robot does not start

cleaning when I press the

start/stop button.

The rechargeable battery is

empty.

Charge the rechargeable battery (see

chapter 'Preparing for use').

The robot is in deep sleep

mode.

Press the start/stop button once to

reactivate the robot.When you press the

start/stop button again the robot starts

cleaning. If the rechargeable battery is

empty,place the robot on the plugged-in

docking station.

English

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Philips FC8772 Robot - SmartPro Compact in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips FC8772 Robot - SmartPro Compact

Philips FC8772 Robot - SmartPro Compact User Manual - English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish - 44 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Philips FC8772 Robot - SmartPro Compact Manual

Product: