Important
◗ Only use Philips s-bag™ double-layer paper
dustbags (type FC8021), or the cotton
dustbag provided (some versions only).
◗ Never use the vacuum cleaner to suck up
water or any other liquid.Never suck up
ashes until they are cold.
◗ When the vacuum cleaner is used to suck up
fine dust, the pores of the dustbag may
become clogged, causing the passage of air
through the dustbag to become obstructed.
As a result,the dustbag-full indicator will
indicate that the dustbag needs to be
replaced,even though the dustbag is not full
at all.
◗ Never use the appliance without the Motor
Protection Filter.This could damage the
motor and shorten the life of the appliance.
Connecting accessories
Hose
1 To connect the hose, push it firmly into the
appliance (you will hear a click).
2 To disconnect the hose, push the buttons on
the swivel and pull the hose out of the
appliance.(fig.1)
Tube
There are two types of coupling systems.
Depending on the type, this appliance is equipped
with one of them. See the systems displayed in
the following pictures.
Conical coupling (specific types only)
◗ Connect the tubes to the handgrip by
inserting the narrow section into the wider
section while turning it a little.(fig.2)
To disconnect the tubes from the handgrip, pull
while turning a little.
Button coupling (specific types only)
◗ Connect the tube to the handgrip by pressing
the spring-loaded lock button on the handgrip
and inserting the handgrip into the tube. Fit
the spring-loaded lock button into the
opening in the tube ('click').(fig.3)
◗ To disconnect the tube from the handgrip,
press the spring-loaded lock button and pull
the handgrip out of the tube.
◗ Use the same method to connect and
disconnect the other accessories.
Telescopic tube (specific types only)
1 Adjust the tube to the length you find most
comfortable during vacuum cleaning.(fig.4)
Reach & Clean nozzle
◗ The Reach & Clean nozzle can be used on
either carpets or hard floors.The nozzle can
be turned 360 degrees to 4 different
positions, allowing you to also vacuum clean
hard-to-reach places in an easy way.When the
nozzle is positioned lengthwise, the suction
power is concentrated at the front side of the
nozzle.(fig.5)
◗ To adjust the nozzle to the type of floor and
the area to be cleaned,put your foot on the
indicated spot and then turn the tube until
the nozzle is in the required position.(fig.6)
1 With the nozzle positioned breadthwise and
the brush strip folded out, you can clean large
hard floor areas.Turn the nozzle until the
brush strip pops out of the nozzle housing
and the nozzle is positioned
breadthwise.(fig.7)
2 With the nozzle positioned lengthwise and
the brush strip folded out, you can vacuum
clean small hard floor areas.Turn the tube 90
degrees anti-clockwise until it is positioned
lengthwise with the brush strip still folded out
of the nozzle housing.(fig.8)
3 With the nozzle positioned breadthwise and
the brush strip folded in, you can vacuum
clean large soft floor areas.Turn the tube 90
degrees anti-clockwise again to position the
nozzle breadthwise and to make the brush
strip disappear into the nozzle housing.(fig.9)
4 With the nozzle positioned lengthwise and
the brush strip folded in, you can vacuum
clean small soft floor areas.Turn the tube 90
degrees anti-clockwise again until it is
positioned lengthwise with the brush strip
still folded in.(fig.10)
Crevice tool, small nozzle and small brush
1 Connect the crevice tool (1), the small nozzle
ENGLISH
6
