Important
◗ Only use Philips s-bag™ double-layer paper
dustbags (type FC8021), or the cotton
dustbag provided (some versions only).
◗ Never use the vacuum cleaner to suck up
water or any other liquid.Never suck up
ashes until they are cold.
◗ When the vacuum cleaner is used to suck up
fine dust, the pores of the dustbag may
become clogged, causing the passage of air
through the dustbag to become obstructed.
As a result,the dustbag-full indicator will
indicate that the dustbag needs to be
replaced,even though the dustbag is not full
at all.
◗ Never use the appliance without the Motor
Protection Filter.This could damage the
motor and shorten the life of the appliance.
Connecting accessories
Hose
1 To connect the hose to the appliance, push it
into the appliance and turn it clockwise.(fig.1)
2 To disconnect the hose from the appliance,
turn it anticlockwise and pull it out of the
appliance.
Tube
Conical coupling (specific types only)
◗ To connect the tubes to the handgrip, insert
the narrow section into the wider section
while turning it.(fig.2)
Use the same method to connect the accessories
to the tube.
To disconnect, turn the tube or the accessories
anticlockwise and pull.
Button coupling (specific types only)
◗ Connect the tube to the handgrip
("click").(fig.3)
Use the same method to connect the accessories
to the tube.
◗ To disconnect the tube from the handgrip,
push the lock button and pull the tube out of
the handgrip.The accessories are
disconnected in the same way.
Telescopic tube (specific types only)
1 Connect the tube to the handgrip ("click").
2 Adjust the tube to the length you find most
comfortable during vacuum cleaning.(fig.4)
Convertible nozzle (specific types only)
The convertible nozzle can be used on either
carpets or hard floors.
1 Connect the convertible nozzle to the
telescopic tube ("click").
2 Push the rocker switch on top of the
convertible nozzle with your foot to make
the brush strip for cleaning hard floors come
out of the nozzle housing.(fig.5)
3 Push the rocker switch again to make brush
strip disappear into the convertible nozzle
housing again.(fig.6)
Reach & Clean nozzle (specific types only)
◗ The Reach & Clean nozzle can be used on
either carpets or hard floors.The nozzle can
be turned 360 degrees to 4 different
positions, allowing you to also vacuum clean
hard-to-reach places in an easy way.When the
nozzle is positioned lengthwise, the suction
power is concentrated at the front side of the
nozzle.(fig.7)
◗ To adjust the nozzle to the type of floor and
the area to be cleaned,put your foot on the
indicated spot and then turn the tube until
the nozzle is in the required position.(fig.8)
1 With the nozzle positioned breadthwise and
the brush strip folded out, you can clean large
hard floor areas.Turn the nozzle until the
brush strip pops out of the nozzle housing
and the nozzle is positioned
breadthwise.(fig.9)
2 With the nozzle positioned lengthwise and
the brush strip folded out, you can vacuum
clean small hard floor areas.Turn the tube 90
degrees anti-clockwise until it is positioned
lengthwise with the brush strip still folded out
of the nozzle housing.(fig.10)
3 With the nozzle positioned breadthwise and
the brush strip folded in, you can vacuum
clean large soft floor areas.Turn the tube 90
degrees anti-clockwise again to position the
nozzle breadthwise and to make the brush
ENGLISH
6
