21129

Philips DVDR7300H Manual

86
Zoom out
Zoom in
Previous page
1/95
Next page
English
87
Troubleshooting
Problem (General) Solution
No power.
The message “IS THE TV
ON?” appears on the display
panel.
The buttons on the recorder
do not work.
Remote control does not
work.
No picture.
WARNING!
Under no circumstances should you try to repair the system yourself, as this
will invalidate the warranty. Do not open the system as there is a risk of
electric shock.
If a fault occurs, first check the points listed below before taking the system for
repair. If you are unable to remedy a problem by following these hints, consult
your dealer or Philips for help.
86
– Press the STANDBY-ON button on the front of the recorder to
turn on the system.
– Make sure the AC outlet has power.
– This recorder will not operate until you complete the first
installation. Read chapter “Step 3: Installation and Set-up” for
details.
– There is a technical problem. Disconnect the recorder from the
power outlet for 30 seconds, then connect again. If the recorder
still will not operate, then reset it to the default factory settings :
1) Disconnect the recorder from the power outlet.
2) Press and hold down STANDBY-ON button on the front of
the recorder while reconnecting to the power outlet.
3) Release STANDBY-ON button when “IS THE TV ON?”
appears on the display. All the information stored in the
memory (programmes, time) will be cleared. You may need
to reset the recorder settings after completing the basic
installation.
– Aim the remote control directly at the sensor on the front of
this recorder (not towards TV). If the recorder receives a signal
from the remote control, the icon D will appear on the display.
– Remove any obstacles between this recorder and the remote
control.
– Batteries are weak, replace the batteries.
– Turn on your TV and set to the correct Video In channel for the
recorder. You may go to Channel 1 on your TV, then press the
channel down button on your TV’s remote control until you see
the TV programme.
– Check the video connection between this recorder and the TV.
– It may be due to the recorder’s video output setting not being
matched to the video connection. You can reset the recorder as
below :
1) Disconnect the recorder’s ~MAINS from the power supply.
2) Hold down
on the recorder whilst reconnect its ~MAINS
to the power supply.
dvdr7300h_eu_eng2.indd 86 2005-10-04 4:16:18 PM
… 86 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips DVDR7300H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips DVDR7300H in the language / languages: English as an attachment in your email.

The manual is 9,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips DVDR7300H

Philips DVDR7300H User Manual - German - 93 pages

Philips DVDR7300H User Manual - Dutch - 93 pages

Philips DVDR7300H User Manual - Spanish - 90 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info