English
FIRST INSTALLATION 13
Requirements for a fast and successful first
installation are as follows:
• You already have an aerial.
• Your aerial is correctly pointed at the
terrestrial transmitter corresponding to
your area (
1).
• Your digital receiver connection is
according to the diagrams depicted in
chapter 2.
1 or 2.2.
• Your TV set is switched on.
3.1 Channel scan
- Connect your receiver to the mains.The
Setup screen appears.The selection is on
Service scan.
- Press <OK> to start scanning for channels.
The following information is reported on
screen:
• scanning progress,
• number of channels found.
When scanning has been successfully
completed, a completion message is displayed.
- Press <OK>. A warning message is displayed.
- Press <OK> again to start watching TV.
To know more about using your digital receiver
consult chapter 4.
If scanning has failed, proceed to chapter 3.2.
3.2 Scanning failure
No channels could be found. A scan failure
message is displayed.
Before starting a new scan
It is recommended you perform the following
checks:
- connections to your receiver (see chapter 2),
- signal quality (see paragraph 5.3.3),
- antenna installation,
- channel(s) available in the region
corresponding to your area (
1).
The scan failure message is displayed.
- Press <OK> to exit this screen and access
the main menu.
- Proceed with installation as described in
paragraph 5.3.2.
Note: if the same failure message appears after a
while, refer to chapter 8.
(1) To check whether you can receive digital
television in your region, consult the web
site WWW.FREEVIEW.CO.UK: type in your
postcode and click on <GO> to see the
coverage for your area.
3.3 Repeated scanning failure
No channels could be found, even after
checking the signal quality delivered by your
aerial.
Either your aerial is not pointing properly at
the digital
TV transmitter, or your aerial
installation needs to be upgraded, or y
ou ar
e
not in the co
v
erage area to correctly receive
digital television. Please refer to the
T
r
oubleshooting guide at the end of this user
manual.
For a proper diagnosis, call your electrical
retailer.
3 First installation