424715
17
Zoom out
Zoom in
Previous page
1/18
Next page
DIAGNOSTICS 17
English
Diagnostics
Fault Possible cause Remedies
Device does not start Short-circuit in the antenna cable or
low-impedance antenna with simultane-
ously active antenna power
Check antenna cable
Remove antenna cable, start receiver and
set option active antenna to OFF, see
p. 10
No mains voltage Check connector cable and pluggable
power supply
No picture, no sound No mains voltage Check connector cable and pluggable
power supply
No channel list or incorrect channel list Carry out automatic channel scan, see
p. 10
Short-circuit in the antenna cable Switch device off, eliminate short-circuit,
switch device on
Defective or missing cable connection Check all cable connections
Antenna badly adjusted Readjust antenna
Lost connection, or cable too long Check connection, shorten cable length
No picture or bad picture Antenna too small Use bigger antenna
SCART plug not completely connected Check SCART connection
Antenna badly adjusted Readjust antenna, see p. 13
Passive antenna does not offer enough
power
Use active antenna and switch on via the
main menu, see p. 10
Channel is broadcasted by means of
other parameters
Carry out automatic scan mode, see p. 10
Sound available, no picture Antenna badly adjusted Readjust antenna
Channel is broadcasted by means of
other parameters
Carry out automatic scan mode, see p. 10
SCART plug not completely connected Check SCART connection
No reception of channels
that could be received
before
Channel is no longer broadcasted Not any
Disturbance by DECT telephone Increase distance between device and tel-
ephone
Antenna badly adjusted Readjust antenna
Remote control does not
work
Obstacle between remote control and
receiver
Eliminate obstacle
Faulty data stream -> device locks Disconnect pluggable power supply, re-
establish connection after 10 seconds
Device is not switched on Switch on device
Batteries are empty Insert new batteries into remote control
Several channels are not
received from time to time
These channels are not broadcasted 24 hours a day and sometimes are not available. This
does not resemble a fault.
Device cannot be operated Obstacle between remote control and
receiver
Eliminate obstacle
GB_Anleitung_Philips_DTR200_Englisch.book Seite 17 Montag, 24. Oktober 2005 10:47 10
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips dtr 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips dtr 200 in the language / languages: English as an attachment in your email.

The manual is 3,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips dtr 200

Philips dtr 200 User Manual - German - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info