368389

Philips avent dect baby monitor Manual

10
Zoom out
Zoom in
Previous page
1/236
Next page
Note: When the parent unit is not in the charger, the battery pack gradually discharges, even when the
parent unit is switched off.
Using the appliance
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
2 Press and hold the on/off button 3on the baby unit until the green power-on light goes
on. (Fig. 11)
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
, The nightlight lights up briey and then fades out again.
, The display lights up and the battery symbol appears on the display (Fig. 12).
, After 2 seconds the temperature and humidity values are shown on the display (Fig. 13).
3 Press and hold the on/off button 3on the parent unit until the sound level lights light up
briey. (Fig. 14)
, The display goes on and the battery symbol appears on the display (Fig. 15).
, The LINK light ashes red and the message ‘Searching’ appears on the display (Fig. 16).
, The LINK light on the parent unit turns green and lights up continuously when a connection
has been established between the baby unit and parent unit. The message ‘Linked’ appears on
the display (Fig. 17).
, After 2 seconds the message ‘Linked’ disappears and the temperature and humidity values
are shown on the display. (Fig. 18)
, The rst time you switch on the parent unit, the message ‘Language’ appears on the display.
Select the desired language (see chapter ‘Menu options, section ‘Setting display
language’) (Fig. 19).
, If no connection is established, the LINK light on the parent unit ashes red. The parent
unit beeps from time to time and the message ‘Searching’ appears on the display, followed by
the message ‘Not Linked’ (Fig. 20).
Positioning the baby monitor
1 Place the baby unit at least 1 metre/3 feet away from your baby (Fig. 21).
2 Place the parent unit within the operating range of the baby unit. Make sure it is at least 1
metre/3 feet away from the baby unit to avoid acoustic feedback (Fig. 10).
For more information on the operating range, see section ‘Operating range’ below.
Operating range
The operating range of the baby monitor is 330 metres/1000 feet in open air. Depending on the
surroundings and other factors that may cause interference, this range may be smaller. Indoors the
operating range is up to 50 metres/150 feet.
Note: If the ECO mode is switched on, the operating range of the baby monitor is also smaller. See
section ‘ECO mode’ in chapter ‘Menu options’.
Dry materials Material thickness Loss of range
Wood, plaster, cardboard, glass
(without metal, wires or lead)
< 30cm/12in 0-10%
Brick, plywood < 30cm/12in 5-35%
Reinforced concrete < 30cm/12in 30-100%
Metal grilles or bars < 1cm /0.4in 90-100%
ENGLISH10
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips avent dect baby monitor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips avent dect baby monitor in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info