545588
27
Zoom out
Zoom in
Previous page
1/101
Next page
However, the TV can also receive commands from a remote
control that uses IR (infrared) to send commands. If you use
such a remote control, always make sure you point the remote
control at the infrared sensor on the front of the TV.
6.5
Pairing with TV
This remote control uses radio frequency (RF) to send its
commands to the TV. Contrary to remote controls using
infrared signals, with this remote control you can send
commands without pointing at the TV.
The TV will notify you when the battery power of the remote
control is low.
Pairing the remote control
For the remote control to communicate with the TV, both TV
and remote control should be paired with each other. Once
paired, you cannot use the remote control to control another
TV.
When you started the initial TV installation, the TV invited you
to press the
OK
key, and by doing so, the pairing was done.
When you switch off the TV, the pairing is stored. You can pair
up to 5 remote controls with this TV.
Pairing again
You can pair another remote control with this TV.
The method to pair a remote control is different for a remote
control already paired with another TV compared with a remote
control that is not paired yet.
The remote control is paired with another TV
To pair, hold the remote control close to the Philips logo (about
10cm) and press the
Red and
Blue key at the same time.
A message will appear if pairing is successful.
The remote control is not paired yet
To pair, hold the remote control close to the Philips logo (about
10cm) and press
OK
. A message will appear if pairing is
successful.
For retail
To pair a new — not yet paired — TV with a remote control
which is already paired with another TV, hold the remote
control close to the Philips logo (about 10cm) and press the
Red and
Blue key at the same time. A message will
appear if pairing is successful.
Note:
If the remote control is still fail to pair the TV, press
>
Setup
>
TV settings
>
General settings
> Reinstall TV, then repeat
pairing step again.
6.6
Batteries
With click door
The TV will notify you when the battery power of the remote
control is low.
To replace the batteries, open the battery compartment on the
keyboard side of the remote control.
1 - Use a small coin or other small, blunt object and press the
square shaped release button to open the battery lid.
2 - Slide the blue lock open in the direction shown by the arrow
and lift the lock.
3 - Replace the old batteries with 2 type
AAA-R03-1.5V
batteries. Make sure the + and the - ends of the batteries line up
correctly.
4 - Push the blue lock down and slide it back until it clicks.
5 - Reposition the battery door and push it down until it clicks.
Put the remote control down for about 15 seconds to calibrate
the pointer.
Remove the batteries if you are not using the remote control for
a long time.
Safely dispose of your old batteries according to the end of use
directions.
For more information, press
Keywords
and look up
End of
use
.
6.7
Cleaning
Your remote control is treated with a scratch-resistant coating.
To clean the remote control, use a soft damp cloth. Never use
substances such as alcohol, chemicals or household cleaners on
the remote control.
27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips 47PFK7509 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips 47PFK7509 in the language / languages: English as an attachment in your email.

The manual is 2,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips 47PFK7509

Philips 47PFK7509 User Manual - German - 124 pages

Philips 47PFK7509 User Manual - Dutch - 120 pages

Philips 47PFK7509 User Manual - Danish - 103 pages

Philips 47PFK7509 User Manual - French - 112 pages

Philips 47PFK7509 User Manual - Italian - 107 pages

Philips 47PFK7509 User Manual - Polish - 112 pages

Philips 47PFK7509 User Manual - Portuguese - 108 pages

Philips 47PFK7509 User Manual - Swedish - 101 pages

Philips 47PFK7509 User Manual - Turkish - 101 pages

Philips 47PFK7509 User Manual - Spanish - 106 pages

Philips 47PFK7509 User Manual - Norwegian - 102 pages

Philips 47PFK7509 Quick start guide - All languages - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info