3
TV
3.1
Switch on
Switch on and off
Make sure you plugged in the mains power on the back of the
TV before you switch on the TV.
If the red indicator light is off, press the small key A on the
right side of the back of the TV to put the TV in standby - the
red indicator will light up.
With the TV in standby, press A on the remote control to
switch the TV on. Alternatively, you can use the CH+, CH-
and h key to switch the TV on.
Quick start
To switch on the TV faster than usual, you can set the TV in
Quick start mode.
In Help, press * List and look up Quick start for more
information.
Switch to standby
To switch the TV to standby, press A on the remote control.
Switch off
To switch the TV off, press the small key A on the right of
the TV on the back. There is no red indicator light. The TV is
still connected to the mains power but consumes a minimum
of energy. To switch off the TV completely, disconnect the
power plug.
When disconnecting the power plug, always pull the power
plug, never the cord. Ensure that you have full access to the
power plug, power cord and outlet socket at all times.
Quick start
With Quick start, the TV can start up faster than usual. When
you switch the TV on from standby the TV picture already
appears after a few seconds, if Quick start is activated.
The TV can remember your daily habit of watching TV. Some
time before you usually switch on the TV, Quick start will
activate automatically, allowing you to switch on quickly.
Alternatively, you can select up to 3 fixed time frames a day
during which the TV is ready to switch on quickly.
When you switch the TV back to standby, Quick start remains
active until the set time frame ends.
Activate
To set the Quick start activation, press h and select S
Setup and press OK to open the Setup menu.
Select TV settings > General settings > Quick start >
Activation. You can select Automatic or Manual.
- Automatic
Select Automatic to activate Quick start automatically. The TV
remembers your watching habit and activates Quick start
during these time frames. With Automatic, the TV can set up
to 4 time frames of 1 hour.
- Manual
Select Manual to activate Quick start during 3 fixed time
frames a day. As an example, you can set a time frame in the
morning, one at noon and one in the evening. For each time
frame, you can set the time span yourself.
If Quick start is set to Manual, you can also select a Standby
delay. With Standby delay, you can set the TV to keep Quick
start active for some time after you switched the TV to
standby. You can set the delay to up to 1 hour in steps of 15
minutes.
Specifics
The TV clock has to work properly to activate Quick start.
Quick start activation cannot be longer than a 4 hour time
frame.
Quick start increases the energy consumption during standby.
3.2
Remote control
