145250
15
Zoom out
Zoom in
Previous page
1/28
Next page
14
Dolby* Pro Logic
Adjust the volume balance level of the loudspeakers
Most programmes will sound good with the volume balance between the
centre left and right and rear loudspeakers in an equally loud position.
However, some programmes may benefit from an adjustment of the level of
the respective speakers.
Which loudspeakers are active depends on the Surround Mode selection you
make below.
& Select Pro Logic in Surround Mode of the
DOLBY PRO LOGIC menu.
é Select Start Test and press the OK key in the centre of the cursor.
A steady noise tone is switched sequentially through the left, centre, right and
rear loudspeakers, for 2 seconds each. This enables you to adjust the volume
of the separate loudspeakers.
The loudspeakers activated light up in the on screen graphic.
Select Centre Volume, Balance or Rear Volume and alter the selected
adjustments.
Select Stop Test in the
DOLBY PRO LOGIC menu and press the OK key when
you have finished the adjustments of the level of the speakers.
Surround mode
Select the Dolby Surround Sound mode according to the sound mode being
broadcast.
When no Surround Sound is available (Dolby 3 Stereo or Off) the wireless
surround loudspeakers are switched to standby after about 15 seconds.
Pro Logic (with Dolby Surround broadcasting)
In addition to the left and right front speakers, the centre and the rear
surround loudspeakers reproduce the Dolby Surround Pro Logic sounds.
This 4-channel sound is always recorded when the movie or programme is
marked with Dolby Surround.
This mode is especially recommended for such programmes as movies.
Dolby 3 Stereo (with Dolby Surround broadcasting)
The Dolby 3 Stereo sound signal is now distributed over the front left, the
front right and the centre loudspeakers.
The rear loudspeakers do not produce any signal.
Hall (with Dolby Surround broadcasting)
The centre sound signal is distributed over the rear loudspeakers which
creates a hall effect from the rear.
The centre loudspeaker does not produce any signal.
This mode is recommended when you wish to add surround sound to a
broadcast which is not encoded Dolby Surround.
Off
This mode reproduces only the left and right front sound signals.
You only hear a stereo sound if the broadcast which you are watching or
listening to is transmitted in stereo or digital sound.
When the wireless surround loudspeakers are disturbed or when there is too much
interference from other external RF equipment, make use of the wired back up
solution. See Install TV Setup, Surround sound, p. 9.
Press the green Ò key to return to the SOUND menu.
‘Dolby’ ‘Pro Logic’ and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories Licensing Corporation.
*
Pro Logic
Hall
Dolby 3 Stereo
Off
SOUND
Dolby Pro Logic
Volume
Graphic Equalizer
Loudness
Headphone
J Dolby Pro Logic
Dolby Pro Logic
Start Test
Stop Test
Centre Volume
Balance
Rear Volume
Surround Mode
J Start Test
Centre
Right
Rear Rear
Left
4810.1 gb /05 19-02-1999 13:40 Pagina 14
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips 28pw9623 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips 28pw9623 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info