4
EN
Specifications
Voltage: 220-240V/50Hz
Power consumption (Standby): less than 5W
Rewind time:
less than 260
seconds (cassette E-180)
Number of video heads : 2
Recording/playback time:
3 hours (SP) (cassette E-180)
6 hours (LP) (cassette E-180)
Weight without packing in kg: 10.5
Dimensions in cm (HxWxD):40.1x37.9x38.0
Power consumption : 52W
Weight without packing in kg: 20.6
Dimensions in cm(HxWxD):51.2x51.0x49.5
Power consumption : 65W
Supplied accessories
• Operating instructions
• Remote control and 2 batteries
21PV385
14PV135 14PV235
Important for the United Kingdom
This apparatus is fitted with a BS1362 5 Amp
inside an approved moulded 13 Amp plug.
To replace a fuse in this type of plug proceed as
follows:
1.
1.Remove fuse cover and fuse.
2.
2.Fix new fuse which should be a BS1362 5A,
ASTA or BSI approved type.
3.
3.Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5A. If a plug without a fuse is
used, the fuse at the distribution board should not
be greater than 5A.
How to connect a plug:
The wires in the mains lead are coloured in accor-
dance with the following code:
BLUE- ‘NEUTRAL’ (‘N’)
BROWN- ‘LIVE’ (‘L’)
4.
4.The BLUE wire must be connected to the termi-
nal which is marked with the letter ‘N’ or
coloured BLACK.
5.
5.The BROWN wire must be connected to the
terminal which is marked with the letter ‘L’ or
coloured RED.
6.
6.Do not connect either wires to the earth termi-
nal in the plug which is marked with the letter
‘E’ or by the safety earth symbol or coloured
green or green-and-yellow.
Before replacing the plug cover, make certain that
the cord grip is clamped over the sheath of the
lead-not imply over the two wires.
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging. You must install the batteries in the
remote control before use.
1.
1.Take the remote control and the enclosed bat-
teries (2 batteries).
2.
2.Open the remote control's battery compart-
ment and place the batteries in it as shown in
the picture and close the battery compartment.
The remote control is now ready to use.
Its range is approximately 7 metres.
Connecting the cable
1.
1.Insert the aerial cable plug into the AERIAL at
the back of the TV-Video Combi.
2.
2.
Connect the mains cable to the wall socket.
3.
3.If the little red standby light (STANDBY ) at
the front panel of the set is not lit, please
switch on the set using the main power
switch. The power switch is located on the
left side panel of the set.
1. Connecting the TV-Video Combi
The severed plug must be destroyed to avoid a
possible shock hazard, or should it be inserted
into a 13A socket elsewhere.