Manual Philips 10FF2XLE (page 7 of 112) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

65267

Zoom out

Zoom in

1/112

Make sure all parts are correctly mounted before you switch on the appliance.

Only use the appliance when both clamps are locked.

Only unlock the clamps after you have switched off the appliance and the lter has stopped

rotating.

Do not operate the juicer for more than 40 seconds at a time when you juice heavy loads and

let it cool down sufciently afterwards. None of the recipes in this user manual constitute heavy

loads.

Do not remove the pulp container when the appliance is operating.

Always unplug the appliance after use.



This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Preparing for use

Wash all detachable parts (see chapter ‘Cleaning’).

2 Pull the mains cord out of the cord storage compartment at the back of the appliance (Fig. 2).

3 Place the juice collector in the appliance (1). To place the pulp container, tilt it forwards

slightly (2). Insert the top end of the pulp container rst and then push home the bottom

end (Fig. 3).

To empty the pulp container while you are juicing, switch off the appliance and carefully remove the

pulp container.

Note: Reassemble the empty pulp container before you continue juicing.

4 Put the lter in the juice collector (1). Hold the lid over the lter and lower it into position

(2) (Fig. 4).

Make sure the lter is tted securely onto the driving shaft (‘click’).

Always check the lter before use. If you detect any cracks or damage, do not use the appliance.

Contact the nearest Philips service centre or take the appliance to your dealer.

5 Snap the two clamps onto the lid to lock it into place (‘click’) (1). Align the groove in the

pusher with the small protrusion on the inside of the feeding tube and slide the pusher into

the feeding tube (2) (Fig. 5).

Make sure the clamps are locked into position on either side of the lid.

6 Put the lid on the juice jug to avoid splattering. Place the juice jug under the spout (Fig. 6).

7 Push the spout downwards before you start juicing.

Note: When the spout is in upward position, it functions as a drip stop when the appliance is switched off.

However, if you leave the spout in upward position during juicing, juice splashes out the spout.

Using the appliance

The appliance only functions if all parts are assembled properly and the lid is properly locked in

place with the clamps.

1 Wash the fruit and/or vegetables and cut them into pieces that t into the feeding

tube. (Fig. 7)

2 Make sure the juice jug is placed under the spout and the spout is in downward position.

3 Turn the control knob to setting 1 (low speed ) or 2 (normal speed) to switch on the

appliance. (Fig. 8)

ENGLISH 7

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Philips 10FF2XLE in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,51 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Philips 10FF2XLE Manual

Product: