506097
28
Zoom out
Zoom in
Previous page
1/61
Next page
ADSL2/2+ Modem Router
www.phicomm.com
23
Chapter 4: Software Configuration
provided by your ISP. For Static IP, you need to specify the IP address, Subnet Mask and Gateway
address.
NAT: Select this option to Enable/Disable the NAT (Network Address Translation) function for
this VC. The NAT function can be activated or deactivated per PVC basis.
Default Route: Select Yes to configure the PVC as the default gateway to internet from this
device.
TCP MTU Option: Enter the TCP MTU as you desire.
Dynamic Route: Select this option to specify the RIP (Routing Information protocol) version for
WAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are both sent in RIP2
format, the difference is that RIP2-M using Multicast, while RIP2-B using Broadcast format.
Direction: Select this option to specify the RIP direction. None is for disabling the RIP function.
Both means the ADSL Router will periodically send routing information and accept routing
information, and then incorporate them into routing table. IN only means the ADLS router will
only accept but will not send RIP packet. OUT only means the ADSL router will only send but will
not accept RIP packet.
Multicast: Select IGMP version, or disable the function. IGMP (Internet Group Multicast Protocol)
is a session-layer protocol used to establish membership in a multicast group. The ADSL ATU-R
supports both IGMP v1 and IGMP v2. Select Disabled to disable this function.
MAC Spoofing: Enable the MAC Spoofing, and enter a MAC address to configure the WAN port.
It makes your inside network appear as a device with this MAC address to the outside world.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Phicomm FD-224 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Phicomm FD-224 in the language / languages: English as an attachment in your email.

The manual is 5,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info