478197
7
Zoom out
Zoom in
Previous page
1/28
Next page
7
Attaching your handle bars with controllers
There are two locations where you can connect your handle bars with controllers to your Mega Quilter 18x8.
These photos show the block that will hold
the handle bars in place on your Mega
Quilter 18x8.
This block is on the front of
the machine or the needle side of the
machine and is used for free motion
quilting.
This block is on the back of the
Machine or the motor side of the machine
and is used when following a pantograph
with the laser light.
Step 1. Remove the two hex screws from the block using the allen wrench provided in your accessory bag.
As you remove the screws the front of the block will come off.
Step 2. Locate your handles which have the controllers attached and also have a 9 pin cable attached to the left
controller.
Step 3. Center the handles on the block and place the front
part of the block back in place and put the screws in. As you
get to the point of the screws being tight ensure that they are
angled good for you.
If you need to adjust the angle of the handles you can loosen
the screws and move the handles up and down to help with
your comfort.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pfaff GrandQuilter 18.8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pfaff GrandQuilter 18.8 in the language / languages: English as an attachment in your email.

The manual is 2,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pfaff GrandQuilter 18.8

Pfaff GrandQuilter 18.8 User Manual - German - 44 pages

Pfaff GrandQuilter 18.8 User Manual - Dutch - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info