631187
47
Zoom out
Zoom in
Previous page
1/68
Next page
Embroidery Preparations
Attach Embroidery/Free-Motion
Foot 6
1. Turn off the power switch to prevent accidents.
2. Turn the hand wheel toward you until the needle is
at its highest point.
3. Disengage the IDT™ system and raise the presser
foot.
4. Remove the presser foot and holder by removing the
presser foot screw (A).
5. Attach the embroidery/free-motion foot 6 to the
presser bar (B) so that the arm (C) of foot should ride
on the shaft (D) of needle clamp. For embroidery,
exchange the needle to an embroidery needle (E).
6. Attach the presser foot screw (A) and tighten it. For
easier access, lower the needle slightly.
To Hoop the Fabric
For the best embroidery results, place a layer of
stabilizer beneath the fabric. When hooping stabilizer
and fabric make sure that they are smooth and securely
hooped.
1. Open the quick release (A) on the outer hoop and
loosen the screw (B). Remove the inner hoop. Place
the outer hoop on a firm flat surface with the screw
on the lower right (B). There is a small arrow in the
center of the lower edge of the hoop which will line
up with a small arrow on the inner hoop.
2. Place the stabilizer and fabric, with the right sides
facing up, on top of the outer hoop. Place the inner
hoop on top of the fabric with the small arrow at the
bottom edge. If you can see the hoop size in the
lower part of the inner hoop, you have attached it
correctly.
3. Push the inner hoop firmly into the outer hoop.
4. Close the quick release (A). Adjust the pressure of
the outer hoop by turning the retaining screw (B).
The fabric should be taut in the hoop for the best
results.
Note: When embroidering additional designs on the same
fabric, open the quick release, move the hoop to the new
position on the fabric and close the quick release. When
changing type of fabric, you might need to adjust the pressure
using the retaining screw. Do not force the quick release.
47
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pfaff Creative 1.5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pfaff Creative 1.5 in the language / languages: English as an attachment in your email.

The manual is 4,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pfaff Creative 1.5

Pfaff Creative 1.5 User Manual - German - 72 pages

Pfaff Creative 1.5 User Manual - Dutch - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info