770982
25
Zoom out
Zoom in
Previous page
1/28
Next page
25
petsafe.com
Troubleshooting
The receiver collar is not
beeping or correcting.
Check the battery to make sure it is installed properly.
Check that both lights are lit on the fence transmitter. If not, perform
the “System Test.”
The receiver collar is beeping,
but the pet is not responding to
the static correction.
Test the receiver collar with the test light by walking toward
the boundary wire. If the test light flashes, adjust the fit of the
receiver collar.
Trim your pets fur where the contact points touch the neck and/or
switch to the longer contact points.
The contact points must be in contact with pets skin.
Increase the static correction level.
Repeat the training steps to reinforce training.
Purchase a stronger receiver collar by contacting the
Customer Care Center.
The receiver collar has to be
held on top of the boundary
wire to activate.
Replace the battery.
Adjust the boundary width control knob clockwise to increase the
distance from the boundary wire that the receiver collar activates.
If using a double loop layout, make sure the boundary wires are
separated at least 5 ft.
If the receiver collar still has to be held on top of the boundary wire,
perform the “System Test.
The receiver collar activates
inside the house.
Turn the boundary width control knob counter clockwise to
decrease the distance from the boundary wire that the receiver
collar activates.
Make sure the boundary wire is not running within
15 ft. of the house. The signal can transmit through the
walls of your house.
Make sure the boundary wires are twisted from the boundary to
the fence transmitter.
The receiver LED indicator light
is flashing every 4 to 5 seconds
and I have just installed a
new battery.
To reset the low battery indicator, remove the battery from the
receiver collar. Discharge all power by holding the correction
level button down until the LED is no longer illuminated. Reinstall
the battery.
I have an inconsistent signal. Make sure the fence transmitter is at least 3 ft. from large metal
objects or appliances.
Make sure all boundary wire turns are gradual.
Make sure the boundary wire is not running parallel to or within
10 ft. of electrical wires, neighboring containment systems,
telephone wires, television or antenna cables, or satellite dishes.
If a neighboring containment system may be causing an inconsistent
signal, move the boundary wire farther away from the neighboring
containment system.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PUL-275 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PUL-275 in the language / languages: English as an attachment in your email.

The manual is 3.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info