Manual Petsafe PIF00-15002 (page 12 of 24) (English)

770990

Zoom out

Zoom in

1/24

1-800-732-267712

Step 5: Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is important for effective training. The Contact Points must have

direct contact with your pet’s skin on the underside of his neck.

Please read and follow the instructions in this manual. Proper fit of the collar is important. A collar worn for too long or made

too tight on the pet’s neck may cause skin damage ranging from redness to pressure ulcers; this condition is commonly

known as bed sores.

• Avoid leaving the collar on your pet for more than 12 hours per day.

• When possible reposition the collar on the pet’s neck every 1 to 2 hours.

• Check the fit to prevent excessive pressure; follow the instructions in this manual.

• Never connect a lead to the electronic collar; it will cause excessive pressure on the contacts.

• When using a separate collar for a lead, don’t put pressure on the electronic collar.

• Wash your pet’s neck area and the contacts of the collar weekly with a damp cloth.

• Examine the contact area daily for signs of a rash or a sore.

• If a rash or sore is found, discontinue use of the collar until the skin has healed.

• If the condition persists beyond 48 hours, see your veterinarian.

• For additional information on bed sores and pressure necrosis, please visit our website.

These steps will help keep your pet secure and comfortable. Millions of pets are comfortable while they wear stainless steel

contacts. Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant of the collar.

If so, you may relax some of these precautions. It is important to continue daily checks of the contact area. If redness or

sores are found, discontinue use until the skin has fully healed.

To assure a proper fit, please follow these steps:

1. Make sure that the battery is not installed in the Receiver Collar.

2. Start with your pet standing comfortably (5A).

3. To make it easier to hear the warning tone, place the Receiver Collar on your pet with the logo side of receiver facing up.

4. Center the Contact Points underneath your pet’s neck, touching the skin.

You may need to trim the hair in the area of the Contact Points. Never shave the dog’s neck; this may lead to a rash or infection.

5. Check the tightness of the Receiver Collar by inserting one finger between the end of a Contact Point and your pet’s neck. The fit should be

snug but not constricting (5B).

a. Allow your pet to wear the collar for several minutes then recheck the fit.

b. Check the fit again as your pet becomes more comfortable with the Receiver Collar.

6. Trim the collar as follows (5C):

a. Mark the desired length of the Receiver Collar with a pen. Allow for growth if your pet is young or grows a thick winter coat.

b. Remove the Receiver Collar from your pet and cut off the excess.

c. Before placing the Receiver Collar back onto your pet, seal the edge of the cut collar by applying a flame along the frayed edge.

5A 5B 5C

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PIF00-15002 in the language / languages: English as an attachment in your email.

The manual is 2.14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Petsafe PIF00-15002 Manual

Product: