770988
20
Zoom out
Zoom in
Previous page
1/24
Next page
1-800-732-267720
Troubleshooting
The Receiver Collar tone is not sounding
when setting up the Boundary Zone.
The tone may be difficult to hear in a noisy environment.
Use Test Light as explained in the “Test Light Instructions” section, and use it
to determine the location of Boundary Zone.
Check that the Transmitter is set up according to directions and install a new
Receiver Collar battery.
The Receiver Collar tone is not sounding
or administering a Static Correction.
Check that the Transmitter is plugged into a working 120 volt outlet, turned
on, the Power Light is on, and the Transmitter controls are set at your
desired settings.
Check receiver battery to make sure it is installed properly.
Replace the battery.
The Receiver Collar tone is
sounding everywhere.
Check that the Transmitter is plugged into a working standard 120 volt outlet,
turned on, the Power Light is on, and the Transmitter controls are set at your
desired settings.
The Receiver Collar tone is sounding
inside the house.
It is recommended to remove the Receiver Collar from your pet when indoors
to avoid activation of the Receiver Collar.
Make sure the Transmitter is on and set up according to the directions.
Ensure the entire house is within the Pet Area. The Transmitter may need to be
moved to adjust the Pet Area to include the entire house.
If relocating the Transmitter, remove the Receiver Collar from your pet before
turning the Transmitter off.
My pet is receiving a Static Correction in
his metal crate.
The Receiver Collar activates when it loses the Transmitter signal. The metal
crate may block the Transmitter signal which causes the Receiver Collar
to activate.
Remove the Receiver Collar from your pet when placing him in his metal crate.
The Boundary Zone seems to fluctuate. This is normal for the electromagnetic field of the Wireless system. The field
may be affected by surrounding “electronic noise,” which can cause it to
fluctuate up to 5%.
The location the Receiver Collar activates is influenced by the speed and
orientation of the Receiver Collar as your pet enters the Boundary Zone.
The Receiver Collar activates in the
middle of the yard.
The Receiver Collar activates when it loses the Transmitter signal. This
sometimes occurs if a large metal object is between the Receiver Collar
and Transmitter, if the orientation of the Receiver Collar changes near the
Boundary Zone, or if the surrounding “electronic noise” interferes with the
signal. If this continues to occur, consider relocating the Transmitter and
resetting the Pet Area.
The Receiver Collar tone is sounding
but my pet is not responding to the
Static Correction.
Make sure the Static Correction Level is set at 2 or above.
Test the Receiver Collar with the Test Light.
If the Test Light flashes, check the fit of the Receiver Collar.
Trim your pets fur where the Contact Points touch the neck and/or switch to
the longer Contact Points.
Increase the Static Correction Level.
Repeat training steps to reinforce training.
My pet reacts strongly to the Static
Correction and has become fearful.
Lower the Static Correction Level.
Make sure you are in control of the situation when your pet receives his first
Static Corrections (have him on a leash attached to a separate, non-metallic
collar) and lead him into the Pet Area and praise him. If your pet remains
fearful, suspend training and start again the next day. Make sure to end all
training sessions on a positive note with lots of praise and play.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PIF00-15001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PIF00-15001 in the language / languages: English as an attachment in your email.

The manual is 2.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info