770955
7
Zoom out
Zoom in
Previous page
1/12
Next page
www.petsafe.net 7
To Test the Vibration Bark Control Collar
1. Begin with the Collar in the OFF position.
2. Turn to the ON position until the LED shows Orange.
3. Immediately turn to the OFF position after seeing the Orange LED.
4. Turn to the ON position. The LED will flash Orange and you are now in test mode.
5. Blow into the microphone and the Orange LED will flash to indicate that the microphone is working.
6. Scratch lightly between the Vibration Points to indicate the vibration is working.
7. If the LED light does not flash and there is no vibration, ensure that the battery is properly
installed, and/or replace the battery. If there is still no response, contact the Customer Care
Center at 1-800-732-2677.
8. Turn OFF to end the test mode. The test mode will also time out after 30 seconds and resume
normal operation.
What to Expect During Use of the Vibration
Bark Control Collar
Important: Do not leave your dog alone the first few times he receives a
Vibration Correction.
Place the Bark Control Collar properly on your dog and wait nearby until he barks. Most dogs will
understand very quickly that the Bark Control Collar is disrupting their urge to bark and will relax
and stop barking. Because the Vibration Correction from the Bark Control Collar may be surprising
or startling at first, some dogs may bark more at the initial correction.
On rare occasions, a dog may get into a bark-correction-bark-correction cycle. If this happens,
reassure your dog with calm, soothing tones. As your dog relaxes, he will understand that if he
becomes quiet, he will not receive any more Vibration Corrections. The small minority of dogs that
have this reaction will only have it the first time they wear the Bark Control Collar.
You should notice a reduction in your dog’s barking within the first couple of days that he wears
the Bark Control Collar. At this point, it is important to remember the learning process is still not
complete. Dogs will “test” this new learning experience and will increase their attempts to bark.
This usually occurs during the second week a dog wears the Bark Control Collar. If this does occur,
remain consistent and do not alter your use of the Bark Control Collar. You must place the Bark
Control Collar on your dog in every situation when you expect him to be quiet. If your dog is not
wearing the Bark Control Collar, he may resume barking and his learning would suffer a setback.
To Prevent Skin Irritation From Occurring
Risk of skin damage. For comfort, safety and effectiveness of this product,
please ensure that you check the fit of your pet’s collar frequently. If any skin
irritation is observed, discontinue the use of the collar for a few days. If the
condition persists beyond 48 hours, see your veterinarian.
Do not attach a leash to the Bark Control Collar. This can result in pulling the
Vibration Points too tightly against your pets neck. You may put a separate
non-metallic collar on your dog’s neck and attach a leash. Do use a harness
for attaching a leash and/or tags while using the Bark Control Collar.
Please refer to page 2 for additional information.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PBC00-12789 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PBC00-12789 in the language / languages: English as an attachment in your email.

The manual is 0.98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info