771304
10
Zoom out
Zoom in
Previous page
1/28
Next page
10 Customer Care Center 1-800-732-2677
STEP 2
Prepare the Receiver Collar
To Insert and Remove the Battery
1. Remove the screws with a small Phillips
screwdriver, applying adequate pressure for
the screwdriver head to fit snugly into the
screw. Remove the Battery Cover (2A).
2. Install one (1), 3-volt (CR2) battery as shown
(2B). Place the Battery Cover back into the
Receiver Collar. Note: Be sure the gasket on
the inside rim of the Battery Cover is intact
each time you replace it.
3. Reinstall the screws. Do not over-tighten the
screws.
Replacement batteries can be found at many
retailers. Contact the Customer Care Center or visit
our website at www.petsafe.net for a list of common retailers.
Risk of explosion if battery is replaced by an incorrect type. Do not short circuit, mix old
and new batteries, dispose of in fire, or expose to water. When batteries are stored or
disposed, they must be protected from shorting. Dispose of used batteries properly.
To Turn the Receiver Collar On
1. Press and hold the On/Off Button until the unit beeps and the Green LED light comes on. (This takes
approximately one second.)
2. Release the On/Off Button. The Green LED will flash once every 5 seconds, indicating the Receiver Collar is
on and ready to receive a signal from the Handheld Remote.
To Turn the Receiver Collar Off
1. Press and hold the On/Off Button until the unit beeps and the LED light shuts off. (This takes approximately
3 seconds.)
2. Release the On/Off Button. Note: To extend the life of the batteries, turn the Receiver Collar off when it is
not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery life will be two weeks.
2A
2B
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PAC00-12893 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PAC00-12893 in the language / languages: English as an attachment in your email.

The manual is 2.69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info