Press the citrus fruit with one hand. The •
appliance automatically starts to press the
citrus fruit. The juice automatically flows
into the jar.
Press the citrus fruit until hardly any more •
juice is extracted from the citrus fruit. The
appliance automatically stops when the
pressure is released.
Note: The appliance automatically changes
direction when it is switched off and on in
order to increase the amount of juice being
extracted.
Stop pressing the citrus fruit in one of the •
following situations:
- no more juice is extracted from the citrus
fruit;
- the jar is filled with the required amount
of juice;
- the jar has reached the maximum
capacity.
Remove the motor housing from the jar.•
Use the jar lid according to the situation:•
- If you use the appliance within a short
period of time, place the jar on the jar lid
to prevent the jar from turning accidentally.
- If you do not use the appliance within a
short period of time, place the jar lid onto
the jar.
After use, remove the mains plug from the •
wall socket.
Cleaning and maintenance
The appliance must be cleaned after each use.
Warning!
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait for the motor to stop running.
- Do not immerse the appliance in water or
other liquids.
Caution!
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
- Do not clean the appliance in the dishwasher.
It is not recommended to wash the
removable parts of the appliance or the
accessories in a dishwasher.
8. Motor housing
9. Dust lid
10. Drip stop control
Initial use
Preparation
Clean the appliance. Refer to the section •
”Cleaning and maintenance”.
Assembly (fig. A)
Warning!
- Before assembly, remove the mains plug
from the wall socket and wait for the motor
to stop running.
Place the motor housing (8) onto the jar •
(1). Make sure that the drip stop control
(10) is fully pressed by the jar (1).
Place the juice collector (7) onto the motor •
housing (8).
Place the pulp collector (6) onto the juice •
collector (7).
Place the small pressing cone (4) onto the •
pulp collector (6).
If required, place the large pressing cone •
(5) onto the small pressing cone (4).
Use
Hints for use
Warning!
- Do not leave the appliance switched on
continuously for more than three minutes.
- Let the appliance cool down for
approximately five minutes after every ten
pressings.
Assemble the juicer. Refer to the section •
”Assembly”.
Cut the citrus fruit in half.•
Place the cut surface of one half onto the •
pressing cone:
- For small citrus fruits (lemons, limes, etc.),
use the small pressing cone.
- For large citrus fruits (oranges, grapefruits,
etc.), use the large pressing cone.
