488227
15
Zoom out
Zoom in
Previous page
1/30
Next page
15
out paper filters.
19 Fill in coffee or espresso powder. The powder
cartridge contains 5.5 to 7.5 g depending on the cof-
fee quality. This is sufficient for one cup of coffee.
20 Press the powder lightly and scrape off at the fil-
ling edge. If too much is filled in, the brewing cham-
ber cannot be closed.
21 Press the lid (22) open and remove any powder
residue adhering to the exterior.
Remove any powder residue adhering to the
exterior thoroughly; they can plug up the pad cassette
(7). The rocking lever (5) then can no longer move to
the right to remove the pad cassette (7). If this should
occur, despite observing the instructions, please pro-
ceed as described at the end of this user manual in
section “Help in case of malfunctions.”
22 Place the powder cartridge into the pad cartridge
in the compartment for 2 pads and 10 lock the
brewing chamber (6) .
15 When the display signals the readiness for
brewing (green), press on the start button .
23 Empty the powder cartridge after brewing. The fil-
ter paper is also bio-degradable as is the coffee pow-
der.
24 25 Rinse the powder and pad cartridge after
every brewing cycle.
Routinely check that the center opening of the
pad cartridge is free (7).
Change coffee quantity
The quantity of coffee powder is optimally adjusted to
one cup in one pad or in the powder cartridge. You
can vary the filling quantity per cup according to your
personal desires and therefore change the strength of
the coffee.
The automatic coffee pad appliance offers the com-
fortable option to individually program the desired cof-
fee quantity for every starting button or .
1. Insert the pad as described above, press the rocking
lever (5) in the area as far left as possible and
wait until the brewing readiness is displayed in
green.
2.Hold the start button to be programmed or
(3 to 4 seconds) until the display flashes
green. During brewing, the programming mode is
active. Watch how the cup fills up. Press the start
button again when the desired quantity is reached.
The brewing stops and the brewing period (active
period of the pump) is programmed. Each new
brewing cycle with this start button now always
occurs at the same brewing period. The prepared
coffee quantity will only vary slightly depending on
the coffee quality.
Information concerning the programming
mode:
The programming mode is active for a maximum of
30 seconds or 60 seconds during
brewing. If you do not press the start button before
brewing ends automatically, the maximum possible
filling quantity will be programmed.
Restore the standard filling quantity
In order to restore the filling quantity to the delivery
state, proceed as follows:
1. Switch the appliance off,
2. Hold the start button (3 to 4 seconds) until
both displays and briefly flash.
Shut-off
The appliance can be switched off at any time by
pressing the ON/OFF button . If it remains switched
on, it is automatically shut off after 60 minutes of the
previous use. The power consumption is less than
0.5 Watts during off-mode.
Filling level display
The fresh water content is constantly monitored by a
movable floating capsule in the water tank (3). The
display flashes red when underrunning the re-
quired minimum filling quantity. The operation is continu-
edas soon as you replace the filled water tank (3).
Decalcification
The appliance must be routinely decalcified as all
hot water appliances. In order to accomplish this, use
the special decalcifier durgol
®
swiss espresso
®
; it can
be obtained from select dealers. If you wait too long
with the decalcification, damages cannot be ruled out.
The following details are guidelines. If you decalcify
earlier, when the crema of the coffee is no longer
optimal, when the coffee quantity is reduced noticea-
bly at the same setting or when the outlet (8) drips
during heating.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petra KM30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petra KM30 in the language / languages: English, French as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Petra KM30

Petra KM30 Additional guide - English, German - 4 pages

Petra KM30 User Manual - German - 6 pages

Petra KM30 Additional guide - Dutch, French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info