as this may cause the housing to melt.
Watersensitive surfaces are unsuitable as
standing areas, as they may be damaged
by water spray.
This appliance is not intended to be
used by persons (including children) with
limited physical, sensory or intellectual
faculties or who lack experience and/or
knowledge, unless they are supervised
by a person responsible for their safety or
have received instructions on how to use
the appliance.
Please make sure that children do
not have an opportunity to play with the
appliance.
Pull the power plug if you do not in-
tend using the appliance for an extended
period.
Risk of scalding due to hot water and
steam. Please observe the information
in this operating manual when using the
appliance.
Risk of freezing! After this appliance
has been vented, i.e. filled with water for
the first time, it may only be used and
stored in frostfree areas. The appliance
could otherwise be damaged. Damage
caused by freezing is not covered by the
warranty.
Prior to first use
Indicators
Low water indicator
Flashing yellow
- Fill the water container (5)
Ready to brew indicator
Flashing green
- Start venting or rinsing
- Programming mode active
Flashing green
- Ready to brew
- Brewing or rinsing function
active Flashing red
- Appliance is heating up
Flashing red
- Energy-saving mode active
Decalcification indicator
Flashing yellow
- Decalcification required
Flashing yellow
- Decalcification programme
active
Yellow lightning symbol
- Water hardness setting
Placement
Wind up and store the section of the 1.
power cable not in use on the under-
side of the appliance.
Stand the appliance on a solid surface 2.
that is not sensitive to water.
The appliance may not be operated
in locations that are higher than 1500 m
above sea level.
Connect the power plug to a shock-3.
proof socket.
Start-up
Switch on the appliance by pressing 1.
the ON/OFF button
(8). As the water
container (5) is still empty, the low wa-
ter indicator
(10) flashes yellow.
Fill the water container with cold tap 2.
water up the its max mark.
Never fill warm, carbonated water or
other liquids, such as milk, etc. into the
container.
Place the water container (5) onto the 3.
appliance. Within a short period the
ready to brew indicator flashes green.
Ensure that the empty pad cartridge (4) 4.
is inserted and turn the control knob (7)
to the position .
Note: You can only turn the control knob
(7) to this position if the pad cartridge is
inserted (4).
Place two large cups next to each other 5.
onto the grate (1).
