Manual PerfectPro SLIM 1 (page 4 of 25) (English, German, Dutch, French)

742546

Zoom out

Zoom in

1/25

POWER SUPPLY

Battery operation

1. Toopenthebatterycompartment,rstturnthebatterycoverxturesanti-clockwise

to loosen and pull down the battery cover.

2. Insert 6 x AM3/AA/LR6 NiMH or alkaline batteries with the correct polarity into the

 compartment.Closethebatterycoverandfastenthexturesbyturningclockwise.

3. If the unit is not to be used for any extended period of time, it is recommended to

remove the batteries from the radio.

The approximate power level of the batteries is displayed in the LCD display of the

 radio.Whenthepowerlevelisverylowthebatterysymbolashesonthedisplay.

The batteries should then be replaced soon to continue normal operation of the

radio.

Notes:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type.

Donotexposethebatteriestoexcessiveheatsuchassunshine,reorthelike.

Batteries should not be disposed of by incineration and with household waste.

Disposable batteries should be taken to a suitable recycling centre if possible.

AC operation

Before plugging the AC power cord into the AC socket, be sure the voltage is correct.

If you have batteries in the radio and using the AC power supply, the batteries will

automatically be disconnect.

AC power cord storage is designed to store the cord when the radio is not in use.

Note:

In order to disconnect the unit from the AC mains completely, the AC power cord should

be removed from the mains socket completely. The AC power cord shall remain readily

operable and should not be obstructed during intended use.

Incaseofmalfunctionduetoelectrostaticdischargeorfasttransient(burst),removethe

power supply and all the batteries then reinstall the batteries and reconnect the power

supply.

GENERAL FUNCTIONS

1. Switching on and off

Press the POWER button to turn the radio on or in standby.

2. Switching in between FM / AUX IN modes

Press the SOURCE button to switch between modes.

3. Tuning the Radio

Tune the radio using the TUNING/SEEK knob on the right.

4. Adjusting the Volume

Adjust the volume with the VOLUME/TONE knob on the left.

5. Adjusting the Tone

Press and hold the Volume knob on the left for about 3 seconds and rotate it to

adjust the Bass and Treble.

USING THE DEVICE FOR THE FIRST TIME

1. Placetheradioonaatsurface.

2. Carefully extend the antenna located on the top of the radio. Adjust the antenna so

it is vertically extending above the radio.

3. Plugging the AC power cord into the AC socket. The radio will automatically perform

an auto scan the FM band in the back ground.

4. When the scan is completed, the 5 strongest FM stations will be stored as presets.

The radio will switch to standby with the updated clock showing on the display.

5. If no signals are found, the clock will not be updated. It may be necessary to

relocate the radio to a position giving better reception.

FM MODE

Seeking station

1. Press the POWER button to turn on the radio.

2. Select the FM waveband by pressing the SOURCE button.

3. IfthisisthersttimetoswitchtoFMmode,thestationinpreset1willbeplayed.

If the radio has been used before, the last listened station will be played.

4. To seek station, press the TUNING/SEEK knob. The scan stops automatically

 whenitndsastationofsufcientstrength.

5. After a few seconds, the display will update and show station name if RDS

information is being received.

6. Tondotherstations,presstheTUNING/SEEK knob again.

7. To seek station in an opposite direction, rotate the TUNING/SEEK knob clockwise

 (toscanfromlowfrequencytohighfrequency)orrotateanti-clockwise(toscan

 fromhighfrequencytolowfrequency),andpresstheTUNING/SEEK knob.

8. When the waveband end is reached, the radio will recommence tuning from the

opposite waveband end.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of PerfectPro SLIM 1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

PerfectPro SLIM 1 Manual

Product: