Manual PerfectPro RB2BT - Rockbox 2 (page 5 of 44) (English, German, Dutch, French)

742406

Zoom out

Zoom in

1/44

POWER SUPPLY

AC operation

Before plugging the AC power cord into the AC socket, be sure the voltage is correct.

If you have batteries in the radio and using the AC power supply, the batteries will

automatically be disconnect.

AC power cord storage is designed to store the cord when the radio is not in use.

Note: In order to disconnect the unit from the mains completely, the AC plug should be

removed from the mains socket completely.

Battery operation

1. Toopenthebatterycompartment,rstturnthebatterycoverxturesanti-clockwise

to loosen and pull down the battery cover.

2. Insert 6 x C size (UM-2) battery with the correct polarity into the compartment. Close

 thebatterycoverandfastenthexturesbyturningclockwise.Closewelltoprevent

moist or dust from entering the compartment.

3. If the unit is not to be used for any extended period of time, it is recommended that

the batteries are removed from the radio.

The approximate power level of the batteries is displayed in the LCD display of the radio.

When the power level is very low the indication “Battery Low!” appears and the battery

symbolashesonthedisplay.Thebatteriesshouldthenbereplacedsoontocontinue

normal operation of the radio.

Notes:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type.

Donotexposethebatteriestoexcessiveheatsuchassunshine,reorthelike.

Batteries should not be disposed of by incineration and with household waste.

Disposable batteries should be taken to a suitable recycling centre if possible.

USING THE RADIO FOR THE FIRST TIME

1. Placetheradioonaatsurface.

2. Carefully extend the antenna located on the top of the radio. Adjust the antenna so

it is vertically extending above the radio.

3. Plugging the AC power cord into the AC socket. The radio will start up and the

display will show “WELCOME TO DIGITAL RADIO” for a few seconds. Then the

radio will automatically perform an auto scan of the Band III DAB channels and the

FM band, the display will show “ATS setting”.

4. When the scan is completed, the 10 strongest FM stations will be stored as presets.

The radio will switch to standby with the updated clock and date showing on the

display.

5. If no signals are found, the clock will not be updated. It may be necessary to

relocate the radio to a position giving better reception.

Additional metal telescopic antenna

You can use this as an alternative antenna for your radio in areas or locations where the

radio-signal (FM/DAB/DAB+) is weak to very weak.

ATTENTION; the standard antenna on the radio is exible, this antenna is not

exible.

Installing:Carefullyscrewoffthestandardexibleantenna.Firstcarefullyloosenthe

antenna with an open-end-wrench (size 14) – turn counter clockwise.

Carefully screw on the metal telescopic antenna and softly tighten it with an open-end-

wrench key (size 14) – turn clockwise

ATTENTION: do not use too much force when xing the antennas as this can

damage the screw threat of the antennas or make it break off.

5 6

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of PerfectPro RB2BT - Rockbox 2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

PerfectPro RB2BT - Rockbox 2 Manual

Product: