Manual Pelgrim wa 68 inox (page 9 of 20) (English, German, Dutch, French)

132895

Zoom out

Zoom in

1/20

USING YOUR HOB

CARBON FILTERS

Note!

The carbon filter must be orde-

red separately.

recirculation hood WA 49/

OWA 490

Position the carbon filter on the

lips at the back and press the

two studs (A) firmly (see fig. 13).

Remove the filter in reverse order.

recirculation hood OWA 490/

WA 48/WA 50/WA 51/WA 59/

WA 92

Centre the carbon filter with the

sunken round surface on top of

the motor frame and turn to the

right (see fig. 14). You will require

2 carbon filters for the WA 50,

WA 59 and WA 92.

recirculation hood OWA 600/900

WA 68

Pull the black knob of the carbon

filter cover (see fig. 15). Insert the

filtering cartridge making sure

that the ”front filtering” symbol

on the cartridge is visible. Place

the cover in reverse order.

No carbon filters are required for

the WA 10/MWA 100 and WA 52.

CLEANING

Switch off the electricity.

Clean the cooker hood with

soapy water, then wipe with

clean water to rinse. Do not use

aggressive cleaning agents such

as soda.

Wash Aluminium filters, once a

fortnight in soapy water. The

colour of the filter will become

dull after washing, this is normal.

The fibre filters can only be was-

hed once or twice and must the-

refore be replaced a couple of

times a year (see the back of this

manual to order

accessories).

Carbon filters cannot be

cleaned to use again. Saturated

carbon is harmful to the

environment and should be

treated as chemical waste.

We advise you to replace the

carbon filter at least twice a year

depending on how much the

cooker hood is used.

recirculation hood OWA 600/900

WA 68

Every time the letter “G”

appears on the display the

grease filter must be washed.

Saturation of the carbon filter is

shown on the display by the

letter “C” (see page 14).

USING YOUR HOB

EXTRACTOR SYSTEMS

To a duct

The cooking vapours are sucked

in via the filter mat and carried

directly outside through the duct.

The cooker hood can be

connected either at the top (B)

(see fig. 5) or at the back (A), as

preferred. Fit the connecting

piece and seal the other ope-

ning off with the cover plate (D)

(see fig. 6). The cooker hood

OWA can only be connected at

the top.

As a recirculation hood

WA 48/WA 49/WA 50/WA 51/

WA 59/OWA 200/WA 92/OWA

490.

Cover the outlets with the cover

plate (D) (see fig. 6). Adjust the

baffle for recirculation. The air

that is sucked in will now be recir-

culated via the filter panel (C).

The carbon filter should then be

fitted (see page 13).

ADJUSTING THE BAFFLE FOR

RECIRCULATION

WA 49/OWA 490

Fig. 7

OWA 200/ 48/ 50/ 59/ 92

Fig. 8

OWA 600/900 WA 68

Fig. 9

GREASE FILTERS

Removing the grease filters.

WA 48/WA 49/WA 50/WA 51/

WA 52/WA 59/OWA 200/WA 92/

OWA 490.

Switch off the electricity!

Remove the plug from the socket

or switch the electricity off at the

mains. Tilt the visor forwards.

Unlock the filter panel (A) (see

fig. 10) and lower it. Lift the hinge

pin (B) out of the slot by pulling

the filter panel towards you on

the right-hand side. Press the

brackets sideways and remove

them, take out the filter

(see fig. 11). Make sure that the

coarse filter netting is face down

on the filter panel.

OWA 600/900 WA 68

Switch off the electricity!

Remove the plug from the socket

or switch the electricity off at the

mains. Press the handles and

remove the filters (see fig. 12).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim wa 68 inox in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,13 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Pelgrim wa 68 inox Manual

Product: