2120
Controls (RSK595/RSK986)
Switching lighting on and off
Press the lighting button .
The lighting comes on.
Press the button again and the lighting goes out.
Switching on the fan
Press the , or button.
The extractor hood comes on at the setting selected. The control light between
the buttons lights up.
Controls (RSK975/RSK981/RSK990/RSK995/RSK999)
Switching lighting on and off
Press the lighting button
/ .
The lighting comes on.
Press the button again and the lighting goes out.
Switching on the fan
Press the
/
button.
The extractor hood switches on.
Change the speed by pressing speed switch /
or /
.
safety
Precautions you must take
■ Have the appliance connected by a qualified fitter (see section "Installation").
■ The panels can be removed by pulling them directly downwards. Use both
hands for this purpose.
■ The panels get hot during cooking. Wait 30 minutes before start cleaning the
panels after cooking.
■ The power supply must be disconnected before the appliance is cleaned or
repaired. Remove the plug from the socket or switch the electricity off at the
mains.
■ We advise you to switch the cooker hood on before you start cooking. Leave
the cooker hood on for another 5 minutes or so after you have finished
cooking.
■ Fats and oils become inflammable on overheating. Never leave such foods
unattended during preparation.
■ A grease-saturated filter mat is inflammable, so never flambé under the
cooker hood, and clean the filter regularly.
■ Switch off the electricity before replacing the light bulbs! Only use the same
sort of light bulbs with the same Wattage.
■ In view of possible sharp edges on the chimney we advise you to wear
working gloves when fitting the chimney.
Extraction systems
The extractor hood must be connected to a duct.
The cooking vapours extracted by suction are carried outside, once the vapours
have been filtered. The cooker hood is connected to the duct at the top using
the outlet flange supplied.