446688
17
Zoom out
Zoom in
Previous page
1/21
Next page
32
33
5 The electric hob4 The ceramic hob
Removing the decorative glass cover
Open the decorative lid. Carefully lift the decorative º
glass cover out of the hinged brackets.
Placing the decorative glass cover
Carefully lower the decorative glass cover into the º
hinged brackets. The decorative lid must only be
placed vertically (see illustration). If this does not work,
then the hinges need to be replaced. Never randomly
switch the location of the hinges, because if they are
wrongly located, then the lid cannot be brought to
a standstill and it can drop down. Attention! Always
check if the decorative lid can be brought to a standstill
after re-installing it. Close the decorative glass cover.
4.3.3 Never use
You should never use scouring agents. These cause scratches in which lime deposits
and dirt can accumulate. Never use sharp objects such as steel wool and scourers. For
cleaning tips refer to the internet site ‘www.atagservice.nl’.
4.4 Faults
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help. Only authorised personnel may open the appliance or carry
out work on the mains power supply. Damage caused by incorrect connection, incorrect
installation or incorrect use is not covered by the warranty. In the case of faults visit the
internet site ‘www.atagservice.nl’.
FAULT CAUSE SOLUTION
Cooking zones do not get
hot.
Plug not, or not completely,
in the socket.
Fuse(s) in the meter
cupboard defective.
Put the plug into the socket.
Check the fuses in the
meter cupboard.
5.1 Operation
5.1.1 Child security
The control knobs are provided with a child security device. You have to push in the knob
first before you can use the hob.
5.1.2 Switching on and off
First switch on all of the elements in the highest setting for
three minutes without pans.
A special rust-resistant coating will be burnt off. This may result in an unpleasant odour.
This is normal.
Switching on
Place a pan on a hot plate, press the control knob and º
turn it to the desired setting.The hot plate will then
heat up.
Switching off
Turn the knob to the 0-setting. Cook with covers on º
the pans: this is quicker and less expensive. The hot
plate remains warm for some time after it has been
switched off. Make use of this extra heat in preparing
your meals.
On/off indicator
As soon as a hot plate is switched on, the indicator lamp
flashes.
1. Burner indication
2. 0-setting
3. High setting
4. Low setting
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim PK754 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim PK754 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info