71520
57
Zoom out
Zoom in
Previous page
1/64
Next page
Instructions for use, installation and connection
57
Removing oven door with a single axe hinge
(certain models only)
Open the door completely and turn the removable locks
backwards (see fig). Then close the door slowly and let the
locks fit to the notches. At an angle of about 15° lift the door
slightly up and pull the door from the hinge supports (fig. 2).
For reinserting the door repeat the procedure backwards. Insert
the door at an angle of about 15° into the hinge supports by
pushing them forward and downwards, so the hinges lock into
their slots (fig. 3). Check if the hinges are locked into their
respective slots.
Now open the door completely and turn the removable locks
into their original position. Close the door slowly and check if
they close properly (fig. 4). If you have trouble closing the door,
check if the hinges are properly inserted into their slots.
Attention! Never let the hinge locks spring out, as the springs
are strong and may cause injuries.
Accessories
Accessories, like biscuit tray, oven grid, etc. are cleaned with
hot water and the usual detergent.
Special enamel
Oven, interior door lining, baking tray and grease interception
pan are coated with special enamel, with smooth and resistant
surface.
This special coating facilitates cleaning at room temperature.
Grease filter
Clean the grease filter after each use with soft brush in hot
water with some detergent, or wash it in the dishwasher.
Oven drawer
The oven drawer is protected from accidental opening.
It may be open by lifting upwards. To remove the drawer
from the cooker pull it out to the limit, then lift upwards and
pull out completely.
Never place any flammable or explosive substances in the
drawer.
The drawer is equipped with side slides on wheels. To insert
it back, slide the wheels into the slide guides and push
inwards
Troubleshooting guide
Any unskilled attempt to repair the appliance is extremely
dangerous as it might cause electric shock and short circuit. To
avoid such injuries any repairs may be performed only by
qualified personnel, or after sales service.
However, there are some minor faults which may be easily
removed by the user, in accordance with the instructions that
follow.
Important!
If the malfunction of the appliance was caused by the improper
use, the service visit during the warranty period is not free of
charge.
Following are some simple advice how to repair minor faults:
Program clock indicates faulty values or switches on and
off intermitently…
Switch the cooker off, disconnect it from the mains for a few
minutes (unlock the fuse or switch off the main switch), then
reconnect it to the mains and set the correct daily time.
Program clock display is flashing…
There was a power failure, or the cooker had been connected
to the mains for the first time. All settings are erased. Set the
correct time of day to be able to activate the oven. After
operating in automatic mode, the oven switches off, the display
indicates time, and the beep is heard. Take the food from the
oven, set the temperature selection knob and the mode knob
into their original positions. Select the "Manual mode", and use
the oven in a conventional mode (without programming).
Signal lamp does not turn on....
are all the required switches properly activated?
is the mains power fuse burned?
is the temperature regulator properly set?
Fuses often burn out...
Call the serviceman or your electrician!
Oven illumination is not on....
Exchange of oven bulb is described in the section
"Replacement of parts".
Oven does not heat up...
is the mains power fuse burned?
is the temperature regulator set correctly?
did you set the oven to the conventional mode after using it
in the automatic mode (programmed)? Switch the mode
button to the position "Manual mode".
Baking results are disappointing...
did you remove the grease filter?
did you follow the instructions and warnings from the section
"Baking"?
did you strictly follow the information from the baking table?
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim PF 6040 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim PF 6040 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pelgrim PF 6040

Pelgrim PF 6040 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info