ASSEMBLY
33
32
INSTALLATION
Assembly
Left- or right-hinged oven door
■ Remove the protective frame by removing
screws 1 and 2 (see Figure 8). Remove the
frame and replace screws.
■ Remove the upper hinge by removing the
two screws. Lift the door from the lower
hinge (see Figure 8a).
■ Re-fasten the hinge to the door.
■ Turn the door around so that the handle is
on the other side.
■ Remove the hinge that is now at the top
(see Figure 8b). Attention: the ring belongs
in the lower hinge.
■ Slide the door into the lower hinge. Place
the ring between the hinge and the hinge
holder (see Figure 8c).
■ Now reassemble the upper hinge.
■ Assemble the protective frame on the other
side of the oven.
Fig. 8a
Fig. 8b
Fig. 8
Fig. 8c
Electrical connection
Two or three phases.
Technical data
oven type 990 970 950
model
combi-oven
with cooker electric gas
electrical connection
230 V ■ ■
230 V
380 V/400V ■
50 Hz ■ ■ ■
nominal
power kW 3 9,9 3
Combination of oven 950/952 with Pelgrim
cooker (see Figure 6)
For installation of this combination appliance,
see the cooker instructions.
Solo oven 990/992 (see Figure 7)
■ Connect oven to the electrical mains.
■ Slide the oven into the cupboard.
■ Open the oven door and fasten the oven
with two screws on each side wall.
Combination of the 970/972 oven and the
Pelgrim electrical or ceramic cooker
After the electrical or ceramic cooker has
been installed in accordance with the
instructions supplied with the appliance:
■ Connect the oven to the electrical mains
and connect the cooker’s 12-pole plug to
the oven’s counter-plug.
■ Now slide the oven into the cupboard.
■ Open the oven door and fasten the oven
with two screws on each side wall.
