557122

Pelgrim MSL920 Manual

52
Zoom out
Zoom in
Previous page
1/58
Next page
GB 10
General
The discharge
The discharge may only be connected to a central mechanical
extraction. Bear in mind the local regulations concerning the ventilation
of gas appliances.
We advise the use of as large a discharge duct as possible. A duct with
a smaller diameter will have a low extraction capacity and produce
higher noise levels.
Bends produce resistance. Make sure that the duct has a smooth run
and has as few bends as possible. Draw the flexible pipe out as far as
possible. Before starting to drill, check that there are no installation
pipes (for gas, water, etc.) present.
The discharge stump has a diameter of 125 mm. It is best if the
discharge pipe also has this diameter.
Electrical connection
The plug should be accessible after the extractor hood is fitted or it
should be possible to disconnect the extractor hood from the mains by
means of a bipolar switch with a contact gap of 3 mm.
Attention
When making the electrical connections, take care that the voltage and
frequency correspond to the values given on the data plate.
If the connection cable becomes damaged, it should be replaced by
the manufacturer’s service department or by a person with equivalent
qualifications, in order to prevent dangerous situations from arising.
Attention
Make sure that there is a sufficient supply of fresh air, if an extractor
hood and a heat source (e.g. gas cooker) that both consume air from
the same room, are switched on at the same time. The maximum
permitted underpressure is 4 Pa.
INSTALLATION
… 52 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim MSL920 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim MSL920 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info