Manual Pelgrim MSL620 (page 51 of 57) (English, German, Dutch, French)

557121

Zoom out

Zoom in

1/57

GB 10

General

The discharge

The discharge may only be connected to a central mechanical

extraction. Bear in mind the local regulations concerning the ventilation

of gas appliances.

We advise the use of as large a discharge duct as possible. A duct with

a smaller diameter will have a low extraction capacity and produce

higher noise levels.

Bends produce resistance. Make sure that the duct has a smooth run

and has as few bends as possible. Draw the flexible pipe out as far as

possible. Before starting to drill, check that there are no installation

pipes (for gas, water, etc.) present.

The discharge stump has a diameter of 125 mm. It is best if the

discharge pipe also has this diameter.

Electrical connection

The plug should be accessible after the extractor hood is fitted or it

should be possible to disconnect the extractor hood from the mains by

means of a bipolar switch with a contact gap of 3 mm.

Attention

When making the electrical connections, take care that the voltage and

frequency correspond to the values given on the data plate.

If the connection cable becomes damaged, it should be replaced by

the manufacturer’s service department or by a person with equivalent

qualifications, in order to prevent dangerous situations from arising.

Attention

Make sure that there is a sufficient supply of fresh air, if an extractor

hood and a heat source (e.g. gas cooker) that both consume air from

the same room, are switched on at the same time. The maximum

permitted underpressure is 4 Pa.

INSTALLATION

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim MSL620 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Pelgrim MSL620 Manual

Product: