692055
21
Zoom out
Zoom in
Previous page
1/60
Next page
EN 7
GENERAL
Introduction to installation
Carefully read the guide before installation the appliances.
The installation requires safety equipment and a range of tool:
The suction table is equipped with all the hardware needed for its installation and is suitable
for most furniture.
Check that the minimum surface and volume required in the base of the cabinet is adequate
for installation.
100 mm
900
600
Minimum height of the cabinet base is very important (min. 100 mm) in order to allow the
passage of the air ducts below the base of the furniture.
The cabinet’s back has to be removed where air ducts are located.
Veneer or other finish of the piece of kitchen furniture into which the hob is to be built in
should be treated with heat resistant glue (100° C); otherwise, the worktop finish may be
discoloured or deformed. Ideally the appliance should be installed with plenty of space on
either side (A). There may be a wall at the rear and a tall unit or wall at one side. On the
other side, however, no unit or divider should stand higher than the appliance (B and C).
To prevent fire it is not possible to place higher cabinets or walls on both sides (D).
Use of wood decoration plates or boards on the worktops behind the appliance is not
permitted.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim IKR2083 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim IKR2083 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pelgrim IKR2083

Pelgrim IKR2083 Additional guide - English - 28 pages

Pelgrim IKR2083 User Manual - English - 52 pages

Pelgrim IKR2083 Additional guide - German - 28 pages

Pelgrim IKR2083 User Manual - German - 52 pages

Pelgrim IKR2083 Additional guide - Dutch - 28 pages

Pelgrim IKR2083 User Manual - Dutch - 52 pages

Pelgrim IKR2083 Additional guide - French - 28 pages

Pelgrim IKR2083 User Manual - French - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info