74365
136
Zoom out
Zoom in
Previous page
1/147
Next page
What should I do if…
If the appliance does not work properly, this does not always mean that it is defective. Try to deal with
the problem yourself first. Phone the service department if the advice given below does not help.
135
faults
Fault
The appliance does not work and
the lights are not on.
The hob does not work.
F9 or FA appears in the display or
the appliance immediately starts
to beep when it is connected.
The hob does not work.
F99 appears in the display.
The fan switches on
spontaneously.
Message F8 appears.
After the zone has been switched
on, the zone displays continue to
flash.
The appliance cannot be switched
on.
Bringing food to the boil takes
longer than expected.
Fault codes F00 in the display.
Fault codes F01 – F11 in the
display.
The indicator warming zone flashes.
Fault codes F1 - F6 in the display.
Cause
No electricity.
The appliance has been
connected incorrectly or the mains
voltage is not right.
Two buttons pressed at the same
time, the glass top is dirty or there
is an object lying on the controls.
The appliance is checking itself
after a power failure.
Overheating of the electronics in
the hob.
Unsuitable pans or no pan on the
cooking zone.
Appliance is locked.
Small pan used.
A control is defective, dirty or has
an object lying on it.
Button operated too long or too
much damp in the appliance.
The warming zone switches off
automatically after two hours.
There is an object on top of the
touch control.
Generator fault.
Solution
Check the electrical installation
(main fuse(s), connection).
check the installation.
Operation error or clean glass top.
The fan switches itself off.
Allow the appliance to cool down.
Press the on/off button and the
indication will disappear. Start
again at a lower setting.
Use a suitable pan (see page 118).
Keep the button with the key
symbol pressed for a few seconds.
Use a pan with a diameter
approximately the same as the
cooking zone.
Clean the appliance or have it
repaired. Do not place objects on
the control panel.
Clean the appliance or have it
repaired. Do not place objects on
the control panel.
Press the touch control for one
second until the red indicator light
goes out.
Remove the object from the touch
control. Press the touch control for
one second until the red indicator
light goes out.
Contact the the service
department.
700001871100_IDK835_4t.qxd 12-10-2005 12:47 Pagina 135
136


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim IDK 835 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim IDK 835 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info