9
FAULTS
faults
Heater fails to light or extinguish.
Causes:
- Air in supply pipe (after appliance has been
out of operation)
.
> Vent.
- Insufficient gas pressure.
> Check that the gas tap is open and check
the gas line to see if it is dirty
.
- The pilot light is dirty.
> Clean the burner carefully with a vacuum
cleaner
.
- The thermocouple contact does not engage
properly.
> Check the thermocouple circuit.
disposing of the packaging and
appliancel
The appliance packaging is recyclable. The
packaging could include the following
materials:
- card board;
- CFC-free foam (soft);
- wood
- plastic;
- paper.
These materials should be disposed
responsibly and in conformity with government
regulations.
Information on how to responsibly dispose of
discarded appliances can be obtained from the
local authorities.
8 CLEANING
maintenance and cleaning
The heater should be cleaned and checked
annually by an authorised installer.
Check that:
-the gas supply is airtight;
-the regulator and the thermocouple circuit
function properly and that the burner ignites
properly.
Clean (if necessary):
-the pilot system;
-the burner;
-the combustion chamber;
-the flue gas exhaust.
cleaning the burner
Once the heater has cooled down sufficiently,
the burner can be cleaned.
Burnt dust gives off an unpleasant smell and
also results in discoloration of walls and
ceilings. Although such discoloration can
never be entirely avoided, it can be restricted
to a minimum by keeping the room, the
housing and the internal mechanism free of
dust.
Discoloration of the housing can be prevented
by cleaning it regularly with soap and water.
After cleaning, rinse thoroughly with clean
water and rub dry. Never use aggressive or
abrasive cleaning agents for the housing.