133008

Pelgrim gwa 810 Manual

19
Zoom out
Zoom in
Previous page
1/23
Next page
3534
2.1 What you need to take into account
Attention! Make sure the appliance is installed by an authorised installer (see
"Installation" chapter). Do not connect the appliance to the flow network before
completing the installation.
• Connect the appliance in accordance with the applicable regulations in your area.
• We advise you to wear protective work gloves during the installation of the exhaust
hood due to possible sharp edges.
• The appliance has been manufactured in accordance with the latest safety standards.
However we do advise that mentally handicapped, disabled or retarded individuals do
not use this appliance without the proper supervision of a competent person. The same
applies to children.
• Never use the exhaust hood when the grease filters have not been properly installed!
• Do not lean against the exhaust hood.
• Make sure there is sufficient circulation when you use the exhaust hood on a gas
cooker.
• The exhaust exit must never be connected to a smoke duct which is also used for other
heating appliances.
• Never flambé under the exhaust hood and always clean the filters on time. Frying needs
to be done under constant supervision to prevent the heated fat from catching fire.
• The exhaust hood needs to be cleaned regularly (at least once a month) on the inside
as well as on the outside. When the filters are insufficiently cleaned or replaced, this will
result in a fire hazard.
• If the connection cable becomes damaged, it should be replaced by the manufacturer’s
service department or by a person with equivalent qualifications, in order to prevent
dangerous situations from arising.
• First disconnect the appliance from the socket when you replace the lights! Only use
identical lamps with the wattage indicated. Only use the exhaust hood with lamps
installed to reduce the risk of electrical shock.
• The filter grid can be removed by pulling it straight down. Do this by using both hands.
• The filter grid with grease filter is becoming hot during operation. Wait a minimum of
30 minutes after cooking before cleaning it.
Appliance description
1 - Moisture collector
2 - Grease filters
3 - Control panel
4 - Lighting
Controls
5 - Lighting switch
6 - Switch for electrical flap or speed regulator fan
Depending on the quantity of moisture you can choose a higher or lower position. Start
the exhaust hood 5 minutes before cooking. Leave the exhaust on after cooking for
another 15 minutes.
When an exhaust hood is connected to a central exhaust circuit you are only able to put
the lights on and off and to open and close the electrical flap.
Apply carbon filter (only in case of re-circulation)
Place the carbon filter in the middle on the motor housing cap and turn it to the right one
full turn.
Introduction
When you read this users manual you will be quickly informed of all the options the
appliance offers you. You will be informed of safety measures and maintenance of the
appliance.
Keep this users manual and the installation guide. This will be of use for any user of this
appliance.
1 Equipment description and use
5
5
6
6
2 Safety
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim gwa 810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim gwa 810 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info