39
CLEANING/INSTALLATION
■ Remove the microfilter (D) by unscrewing
the bayonet catch.
■ Remove the filter mesh by squeezing the
filter housing (see fig. 13c). Simultaneously,
pull out the filter mesh vertically.
■ Clean filter mesh and filter with a brush
under running water.
■ Reassemble the filter mesh and filter in
reverse order.
Installation
Electrical connection
230 V – 50 Hz
General
If the appliance does not have a connecting
cable and plug, then it may only be connected
to the mains by an approved installer.
Note:
The power rating and required mains voltage
are shown on the rating plate. Connection
should take place according to national and
local regulations.
If the input of the appliance exceeds 3 kW, the
appliance has to be connected to an outlet
with a rated current exceeding 13 Amp.
Technical information
Connected load kW see identification
plate
Dimensions:
Max. height mm 870
Min. height mm 820
Width mm 596
Depth mm 550
Door panel:
Max. height* mm 600
Min. height mm 500
Depth mm 598
Control panel
Max. height mm 155
Min. height mm 115
Plinth:
Max. height mm 170
Min. height mm 100
* at minimal control panel height
What else you should watch out for
■ Always fit tap, drainage and earthed
plug/wall socket within reach.
■ Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
■ Connect water inlet hose/aquastop to a
self-venting water tap with a 3/4" screw
connection.
Make sure that no dirt remains in a newly-
installed water pipe.
