634537
83
Zoom out
Zoom in
Previous page
1/100
Next page
EN 11
OPERATION
Switching on
1. Open the door to the dishwasher.
2. Add detergent and rinse agent (consult 'Dishwasher detergents' and 'Rinse aid’).
Check the amount of salt in the salt reservoir (consult ‘Adding Salt’).
3. Press the “on/off” button to switch on the appliance.
A cycle indicator will light up when the appliance is switched on.
4. Select the desired cycle (see cycle selection table”).
Press the programming button repeatedly to select the required cycle. The cycle indicator
corresponding to the selected cycle will light up.
5. Close the door. The dishwasher will automatically start running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used the “delayed start”
button. You can choose to delay the start time by 1 to 24 hours. Each press of the button
changes the delay time. The display show the delayed start time that has been selected.
Stopping or changing a wash cycle
Open the door. Press and hold the programming button for more than 3 seconds. You can
now re-select the desired cycle (see “cycle selection table”). Now close the door.
Note! A cycle that has already begun can only be changed in the start-up phase. After
this, the detergent will be sprayed all over the dishes or the machine may have already
pumped out the water. In that instance, you must refill the detergent compartment (see
section on Detergent compartment).
Following the end of the wash cycle
Once the wash cycle has completed, an audible signal will sound for eight seconds.
Switch the appliance off using the on/off button.
Open the door to the dishwasher. Wait a few minutes before unloading the dishwasher.
The dishes and cutlery will still be very hot immediately following the end of the cycle.
There is a chance that dishes may break as a result of the heat. Moreover, the dishes
dry better when allowed to stand for a few minutes.
Flood protection switch
Your dishwasher is fitted with a safety switch that prevents too much water from running
into the appliance. The safety switch closes the inlet valve and instructs the dishwasher to
pump out the surplus water. If there is water in machine (due to too much water being fed
in previously, or as a result of a leak), this must first be removed before the appliance is
switched on again.
83


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim GVW476 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim GVW476 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pelgrim GVW476

Pelgrim GVW476 Installation Guide - English, German, Dutch, French - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info