37
36
CLEANING/INSTALLATION
Installation
Electrical connection
230 V – 50 Hz
General
If the appliance does not have a connecting
cable and plug, then it may only be connected
to the mains by an approved installer.
Note:
The power rating and required mains voltage
are shown on the rating plate. Connection
should take place according to national and
local regulations.
If the input of the appliance exceeds 3 kW, the
appliance has to be connected to an outlet
with a rated current exceeding 13 Amps.
Technical information
Connected load kW see identification
plate
Dimensions:
Max. height mm 870
Min. height mm 820
Width mm 446
Depth mm 550
Door panel:
Max. height mm 720
Min. height mm 448
Depth mm 598
Plinth:
Max. height mm 170
Min. height mm 100
What else you should watch out for
■ Always fit tap, drainage and earthed
plug/wall socket within reach.
■ Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
■ Connect water inlet hose/aquastop to a
self-venting water tap with a 3/4" screw
connection.
Make sure that no dirt remains in a newly-
installed water pipe.
CLEANING
Cleaning
First disconnect the appliance from the power
supply (see also page 22).
Spray arms (see fig. 9)
■ Take out the upper spray arm by pulling it
– with a turning movement – vertically
downwards.
fig. 9
■ Take out the lower spray arm by pulling it
vertically upwards (see fig. 10).
Rinse the spray arms clean under the tap.
Microfilter (see fig. 10)
fig. 10
■ Remove the filter unit by turning the clips
(A) a quarter of a turn to the left and lifting
them straight out.
■ Remove the microfilter (B) by unscrewing
the bayonet catch.
■ Press on the clips (C) and remove the filter
mesh.
■ Clean the filter mesh with a brush under
running water.
■ Reassemble the filter unit in reverse order.
Course filter (see fig. 11)
fig. 11
■ Remove the spray-arm mounting (A) by
turning it anticlockwise.
■ Remove the course filter (C).
■ Clean the course filter under running water
using a brush.
■ Fit the course filter, spray-arm mounting
and cap in reverse order.
C
A
B
B
C
A
